User Manual

Kuma
User manual
Thank you for purchasing the Lightpro Kuma.
This document contains the required information for
correct, efficient and safe use of the product. Consult the
user manual of your transformer for more information
about the installation and connection of your lighting
plan or visit our website www.lightpro.nl
Read the information in this manual carefully before
using the product. Keep this manual near the product for
consultation in the future.
PRODUCT DESCRIPTION
The Lightpro Kuma is an LED wall lamp for outdoor use.
The fixture can be mounted on a solid surface or placed
in the ground with the supplied spikes. This product may
only be used as outdoor lighting in combination with
the Lightpro 12-volt system. Any alterations made to the
product may have consequences for the safety, guarantee
and correct functioning of the product and/or other parts
of the system.
SPECIFICATIONS
Product Lightpro Kuma
Article number 184W
Light source LED 6W AC/DC 12V
Power (max) 6W
Luminous flux (max) 300 lm
Light colour 3.000K
Average lifetime 25.000
Dimensions (H x Ø) 35 x145 mm
Protection class IP44
Ambient temperature -20 °C to 50 °C
Cable length 3m
Dimmable No
Light source Not replaceable
On/off 10.000
PACKAGING CONTENT
[Figure A]
1. Fixture Kuma
2. Screws
3. Plugs
4. Lightpro connector
5. Hex key
Check if all parts are present in the packaging. For
questions about parts, service, and any complaints or
other remarks, you can always contact us.
E-mail: info@lightpro.nl.
INSTALLATION
[Figure B]
1. Remove the screws from the fixture with the included
key (Figure A [5]).
2. Remove the hood from the fixture.
[Figure C]
Optional: Putting the cable through the wall.
1. Drill a hole (Ø10 mm) in the wall for the cable.
2. Open the screw connector in the cable.
3. Put the cable through the hole in the wall.
4. Connect the screw connector in the cable.
[Figure D]
1. Install the back plate with the included screws.
If necessary, drill holes in the wall and use the included
plugs.
[Figure E]
2. Place the hood over the back plate.
3. Place the screws in the fixture.
4. Fix the hood by fastening the screws with the included
key (Figure A [5]).