User Manual

Tranformer + Timer / Sensor
User manual
Thank you for purchasing the Lightpro Transformer +
Timer / Sensor.
This document contains the required information for
correct, efficient and safe use of the product.
Read the information in this manual carefully before
using the product. Keep this manual near the product for
consultation in the future.
SPECIFICATIONS
Product Lightpro Transformer +
Timer / Sensor
Article number Transformer 60W - 144A
Transformer 100W - 145A
Dimensions (H x W x L) 162 x 108 x 91 mm
Protection class IP44
Ambient temperature -20 °C tot 50 °C
Cable length 2m
PACKAGING CONTENT
1. Transformator
2. Screw
3. Plug
4. Cable lugs
5. Light sensor
Check if all parts are present in the packaging. For
questions about parts, service, and any complaints or
other remarks, you can always contact us.
E-mail: [e-mail].
INSTALLATION
Mount the transformer with the setting knob pointing
downwards <Fig. A>. Attach the transformer to a wall,
partition or pole (at least 50 cm above the floor). The
transformer is equipped with a light sensor and a time
switch.
Light sensor
<Fig. B> The light sensor is fitted with a 2 metre long
cable. The cable with sensor can be disconnected, for
instance to be led through a hole in the wall. The light
sensor <Fig. B1> is mounted with a clip <Fig. B2>. This clip
must be attached to a wall, pole or similar. We advise to
install the light sensor vertically (facing upward). Mount
the sensor to the clip and connect the sensor to the
transformer <Fig. A2>.
Mount the light sensor in such a way that it cannot be
influenced by light from the outside environment (car
headlights, street lighting or the own garden lighting,
etc.). Ensure that only day and night natural light can
influence the functioning of the sensor.
Should the 2 metre cable not suffice, then the sensor
cable can be lengthened by use of an extension cord.
Setting the transformer
The transformer can be set in different ways. The light
sensor <Fig. B1> works in combination with the time
switch <Fig. C>. The lighting switches on at sunset
and switches off after the set number of hours or
automatically at sunrise.
- “Off” switches the light sensor off, the transformer
switches off completely
- “On” switches the light sensor on, the transformer is on
continuously (this may be necessary for testing during
day hours)
- “Auto” switches the transformer on at dusk, the
transformer switches off at sunrise
- “4H” switches the transformer on at dusk, the
transformer switches off automatically after 4 hours
- “6H” switches the transformer on at dusk, the
transformer switches off automatically after 6 hours
- “8H” switches the transformer on at dusk, the
transformer switches off automatically after 8 hours