User Guide

Lightolier is a Philips group brand
Job Information Type:
631 Airport Road, Fall River, MA 02720 • [phone] • Fax [phone]
We reserve the right to change details of design, materials and finish.
www.lightolier.com © 2008 Philips Group • C0808
Lytespan
®
Track Lighting 9100
Page 2 of 4 Radius™ Track 1 Circuit Track
Junction Box Cover
Mounts above "L" feed 9155WH,BK or
"T" 9151WH, BK. Mounts to a 4" or 3"
octagon outlet box. Direct mount track to
surface. Canopy is 3/32" thick and 4-1/2"
square.
9060WH Matte White
9060BK Matte Black
Direct Mounting
Toggle Bolts and Nylon Insulators are
furnished with the Track: 2 per 2', 4', and 6',
3 per 8'. Mount toggles through existing
holes in track. Top of track is flush to ceiling.
Recommended for wall and ceiling mounting.
Additional supports may be required when
wall mounting or when using heavy lighting
fixtures on the Radius track.
Suspended Grid Ceiling Mounting Clips
Square Edge Panels and 9/16" - 15/16" T-Bars
Clip attaches at any point along a straight
section of T-Bar by rotating the clip. Pass clip
stud through existing holes in track and
secure with nut.
Additional supports may be required when
supporting heavy lighting fixtures on the
Radius track.
9189 (9) Clips
9/16" - 15/16"
Square
Edge Panel
T-Runner
9/16"-
15/16"
Regressed
Edge Panel
T-Runner
5/16" -
13/32
Toggle Bolt
Nylon Spacer
Regressed Edge Panel Mounting Clips
9/16" - 15/16" T-Bars
Clip attaches at any point along a straight
section of T-Bar by rotating the clip. Pass clip
stud through existing holes in track and
secure with nut.
Additional supports may be required when
supporting heavy lighting fixtures on the
Radius track.
9188 (9) Clips
Live End Canopy
Mounts directly under a 4" or 3" octagonal
outlet box. Live End Canopy attaches
mechanically to the J-Box. The canopy is
polarized (meaning the connector goes into
the track one way, providing consistent
alignment of the neutral and hot wire
connections with the track
and lighting fixtures).
9160WH Matte White
9160BK Matte Black
Saddle Canopy Kit
Mounts anywhere along the track (excluding
track mounting hole locations) for power feed
from a 4" or 3" octagon box. Track must be
mounted at 45ϒ to the mounting holes when
using a 3" J-Box. Max load 20 amp. at 120V
60Hz.
9163WH Matte White
9163BK Matte Black
45ϒ
Track Unit
3" Octagon J-Box
(by others)
1-3/16"
Dead End Cover
Electrical Fitting
Canopy Cover
4-1/2"
square
3/16"
Centerline
J-Box
4 3/8"
Square
1/2"
Track Unit
Canopy
NEUT
GND
3/23"
4-1/2"
Slot
Outlet Box
(by others)
4-1/2"
Canopy
Supply Leads
Ground Wire
Screw