User Guide

INSTRUCTION SHEET NO.
1S:8276
0892 Page20f2
OPERATION
1. AIMING ADJUSTMENTS
Simply rotate LYTESPOT to the desired position as indicated in Fig. 1.
FIG. 1
1. LAMPING
To prevent electrical shock, turn off power to track. Pull louver straight out with both hands. To remove lamp, swing lamp from the end until
it snaps out of holding clip, then pull sideways until it detaches from the lamp socket (see Fig. 2), Install new lamp. Replam louver by lining
up locking tabs to the inside edge of fixture’s opening, then push louver until it snaps in position. See list below for selection of appropriate lamp.
PROD. #
(12”) 8276- Twin Tube 18W
(14) 8277- Twin Tube 27W
FIG. 2
LOCKING
TABS