User Guide

(
(
STEP3
R
,.,.,.,
.,,
”
..... ,.,.,.,..,,
:,,.,’ .,, ,, . .
REFLECTOI
HOUSING
F
SOCKET CUP
SIDE
OPENING
F
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
INSTRUCTION SHEET NO.
This fixture is intendedfor installationin accordancewith the NationalElectricalCode and local
regulations.To
assure full compliance with local codes and regulations, check with your local electrical
inspector before installation.
Toprevent eleckical shock, turnoff electricity at fuse box before proceeding.
IS:1105T
Retainthese instructionsfor maintenancereference.
R0791 Page 1 of 2
INSTRUCTIONS FOR LWECASTER REFLECTOR TRIM INSTALLATION IN THE
II02T SERIES FRAME-IN KIT
INSTALLINGREFLECTORTRIM
1,Installframe-in kit. (Seeframe-in kit instructionsheetfor installation
STEP1
procedure,)
2. Rotate(4) roto-clipsclockwiseso thattheshortlegsextendinwardtoward
the center opening, (NOTE:The short leg of the roto-cliphas no return
on top.)
3. Insertsocket cup through side opening inthe reflectorhousingand pull
through (DO NOT SNAP CUP IN PLACE).
4. Align side opening onreflectorhousing directly opposite of J-box assembly
(See diagram for STEP 5) and push reflector housing straight up until it is
secure against the ceiling, Makesure that side openingon the reflector
housing clears the roto-clipswhile it is being pushedin place.
NOTE:To removereflectorhousing,turn counterclockwisewhile pulling
downward,
STEP2
5, Pushsocketcup intosideopeningin reflectorhousingandsnapin place.
SHORT LEG
Y
ONG LEG
(with return)
LAMPING
1. Use (2) 13W twin tube compact fluorescent lamps,
7G
2. To lamp fixture, insert the head of the lamp through the lamp openings in
‘“ME> “
the reflector housing and then insert the base of the lamp into the socket,
CE’’L’NGV:’:;+ :.:0
ROTO-CLIP
(4)
Yi:-
?
LBC31=[
7-C>1-1E R“
ER#R?:;s%it