Manual

LED Bathroom Recessed Ceiling Fixture GX53 –
AQUA
TECHNICAL SPECIFICATION:
Instruction Manual
Series Name AQUA
Model Number LM85666-2 LM85667-2
Color Chrome
LM85484-2 LM85485-2
Silver leaf
Lamp Holder GX53
Incl. Lamp
8W
G G
8W
LM85669-2
LM85492
Black
G
8WLamp Wattage
Total Luminous Flux 650lm
Voltage 220-240V~
Frequency
IP Rating
50Hz
IP44
Light source energy efficiency class <X>
IDV GmbH | Birkenweiherstraße 2 | D-63505 Langenselbold | Germany | www.lightme.eu
Correct disposal of this product:
This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or
human health from uncontrolled waste disposal, recycle it responsibly, to promote the sustainable reuse of material resources. To return your device, please use the
return and collection systems, or contact the retailer where the product was purchased. They can take this product for environmental safe recycling.
ATTENTION:
Instant start is allowed.
The luminaire may only be used with GX53 LED lamps!
IP44 waterproof protection, designed for indoor applications.
The operating temperature of the luminaire is -20˚C to +40˚C.
CAUTIONS:
Read the entire manual carefully before installation and operation.
Important warning for drilling in walls: before drilling, make sure that there are no gas and water pipes or power lines behind or near the drilling spots. Drilling and
mounting should be performed only by qualified personnel. Be sure to pay attention to the condition and material of the walls, as the supplied mounting material is
not suitable for all wall types. Please inquire about recommended screws and raw plugs for your wall type and wall condition. The manufacturer accepts no liability
for improper wall raw plug mounting and the herefrom resulting damages.
Installation or replacement should be performed only by licensed and qualified electricians.
DO NOT disassemble the inner part of the luminaire. Doing so may result in luminaire damage or malfunction.
Switch OFF the power source before installation, replacement and cleaning!
Wearing gloves during installation is recommended to ensure the luminaire is kept in the best condition.
Before replacement of the lamp or luminaire, turn it off and allow it to cool down. Heat-resistant gloves are mandatory when handling the luminaire.
The manufacturer accepts no liability for any damage resulting from the misuse of the luminaire or from when it is used with inappropriate equipment.
Consult your dealer if you have any enquiries.
This product contains a light source of energy efficiency class <X >
INSTALLATION ( LM85666-2, LM85667-2,LM85669-2 )
1
OFF
1. Turn OFF the power.
2. Drill the 90mm-diameter cut hole in the
ceiling.
3. Connect the cable to the terminal
block.
4. Insert the luminaire in the drilled cut hole.
5. Insert the lamp LM85484-2/LM85485-2/
LM85492 into the lamp holder.
6. Turn ON the power.
GB
IP44
6
ON

Summary of content (1 pages)