Manual

6
SECURITY KIT (ATNSG2)
Simple-to-install security bolts and nuts help
protect your investment against theft. This kit
contains 4 x M10 x 35mm anti-theft bolts plus
2 x M10 security nuts for the mounting bolts,
both with corresponding coded keys requiring a
17mm, 11/16” spanner.
All bolts are machined from 304 stainless steel.
The key will only t the anti-theft bolts/nuts in
one position. Coded key is machined from steel
with zinc protective coating.
INSTRUCTIONS FOR SECURING
LIGHT TO MOUNTING BRACKET
USING THE SECURITY KIT
1. Remove the standard M10 bolts and washers
from each side of the existing mounting
bracket and t the anti-theft bolts using the
security nut socket, reusing the existing
washers
2. Remove the standard M10 nyloc nut and
replace with anti-theft nyloc nuts as per the
diagram below.
STRIKER LED ACCESSORIES
Fig 8. Security Kit Mounting
DRIVING LIGHT FILTERS
Durable polycarbonate covers should remain
tted to driving lights at all times. Capable of
absorbing road grime and bombardment for
many years, these replaceable covers should
be renewed from time to time to protect your
investment and maintain maximum output.
Your Striker LED lights come standard with clear
spot lters (STRIKERFCS).
Clear combo (STRIKERFCF) and clear ood
(STRIKER FCC) lters are also available and can
be used to achieve a wider driving light beam
pattern or diffused ood of light.
STAINLESS STEEL BRACKET
This stainless steel bracket (STRIKERLEDBKT)
is supplied with an M10 x 35mm coach head
bolt with a nut and washer. These can be used
to mount a Striker LED vertically or horizontally
to any solid surface and allows the user more
exibility in directing the light.
TUBE MOUNTING BRACKETS
Lightforce supplies a variety of tube mounting
brackets to allow you to easily mount your
Striker LEDs to common nudge and roll bars.
SINGLE STRIKER LED
Lightforce supplies single Striker LED
Driving Lights (DLSTRIKERLEDX1) which are
packaged with a spot lter, a reversible mount
and hardware, user instructions and a 2 pin
waterproof connector.
The 2 pin waterproof connector allows the single
Striker LED to be wired into a Lightforce Driving
Light Harness.
Please consult the user instructions provided
with the single Striker LED for more information
on installation.
Nut Socket