Manual

5
STEP 4. INSTALL THE DASH SWITCH
1. Find a suitable place on the dash to mount
the dash switch.
2. Disconnect the spade terminals at the back
of the dash switch (refer to gure 7 below)
3. Unscrew the plastic nut from the rear of
the dash switch
4. Carefully drill a hole for the dash switch
using a 12mm drill bit.
5. Push the dash switch through the hole, re-t
the plastic nut and reconnect the spade
terminals to the dash switch according the
switch wiring diagram in Figure 6.
STEP 5. CONNECT THE DASHBOARD
SWITCH LOOM
1. Route the dashboard switch loom
connector (on the driving light harness)
carefully through the vehicle’s rewall using
pointy nose pliers to pull the cable through.
A torch will help you to see what you are
doing. Be careful to avoid crushing the
connector. Ensure the wires are kept away
from any heat sources
2. Connect the dashboard switch loom
connector on the driving light harness (see
item 1, gure 1) to the dashboard switch
loom pictured in Figure 7 below. Note that
this standard switch illuminates only when
turned on.
If you are using a different switch with dash
illumination (not included), connect the dash
illumination cable (on the switch loom) to your
switch, as directed by the user instructions for
the switch.
STEP 6. CONNECT TO THE BATTERY
1. Connect the ring on the red wired battery
connector to the positive battery terminal
using a spanner
2. Connect the ring on the black wired battery
connector to the negative battery terminal
using a spanner.
STEP 7. SECURE CABLES
1. Use the supplied cable ties to secure all
loose cables and remove excess using wire
cutters.
STEP 8. TEST
1. Turn on the ignition and test correct light
operation by switching on your high beam.
Ensure the lights only activate when
switched to high beam.
STRIKER LED INSTALLATION INSTRUCTIONS
Fig 7. Dashboard switch loom
Dash illumination cable
Dashboard switch loom connector
Dash switch
Black (Negative)
Blue (Relay)
Red (High beam)
Fig 6. Dash switch wiring
(front view)
Plastic nut
Spade terminals