USER INSTRUCTIONS STRIKER LED USER INSTRUCTIONS 1
STRIKER LED INSTALLATION INSTRUCTIONS DIY TWIN PACK WITH INSTALLATION KIT CONTENTS TOOLS AND CONSUMABLES REQUIRED • 2 x Striker LED driving lights • Spanner to access battery terminals • 2 x Spot filters • Ratchet with 3 inch extension • 2 x Reversible mount and hardware • 17mm deep and shallow socket • 1 x User instructions • Pointy nose pliers • 1 x DIY harness installation kit • Wire cutters • 1 x Driving light harness • Drill • 1 x HB3 patch harness • 12mm drill bit • 1 x H4 patch har
STRIKER LED INSTALLATION INSTRUCTIONS TECHNICAL SPECIFICATIONS • Power: 60 Watts • Distance to 1 lux (pair): 754m • Distance to 1 lux (single): 533m • Input voltage range: 10 – 30V • Current draw: 4.4 Amps @ 13.2V • Colour temperature: 5000K • LED estimated lifespan: 50,000 hours • Operating temperature: -40° to 63°C GENERAL CARE AND SAFETY TIPS To wash your lights, use plenty of warm soapy water and a soft cloth only (this prevents surfaces from marking).
STRIKER LED INSTALLATION INSTRUCTIONS Fig 1. Driving Light Harness 1. 40 amp Relay 1 2. Insulated sleeved wires 3. Battery connector (negative) 4. Battery connector (positive) 5. 15 amp fuse 6. Driving light connectors 7. High beam pickup wire with bullet terminal (negative) 2 8. High beam pickup wire with bullet terminal (positive) 9. Dashboard switch loom connector 10. Dash illumination cable (optional). Yellow 10 5 Green 7 Black 3 Fig 2. Screw for fixing relay Red 4 8 9 Fig 3.
STRIKER LED INSTALLATION INSTRUCTIONS STEP 1. MOUNT THE LIGHTS 1. Install the driving lights onto a suitable mounting surface 2. Remove the nyloc nut and M10 washer from M10 x 35mm bolt attached to the bottom of mounting bracket 3. Locate the bracket in a suitable position using the M10 x 35mm bolt. It is recommended that the base area of the mounting bracket is totally supported 4. Align the light to preferred driving position 5.
STRIKER LED INSTALLATION INSTRUCTIONS STEP 4. INSTALL THE DASH SWITCH STEP 6. CONNECT TO THE BATTERY 1. Find a suitable place on the dash to mount the dash switch. 1. Connect the ring on the red wired battery connector to the positive battery terminal using a spanner 2. Disconnect the spade terminals at the back of the dash switch (refer to figure 7 below) 3. Unscrew the plastic nut from the rear of the dash switch 4. Carefully drill a hole for the dash switch using a 12mm drill bit. 5.
STRIKER LED ACCESSORIES SECURITY KIT (ATNSG2) DRIVING LIGHT FILTERS Simple-to-install security bolts and nuts help protect your investment against theft. This kit contains 4 x M10 x 35mm anti-theft bolts plus 2 x M10 security nuts for the mounting bolts, both with corresponding coded keys requiring a 17mm, 11/16” spanner. Durable polycarbonate covers should remain fitted to driving lights at all times.
For warranty information and to register your product for warranty purposes, visit lightforce.com/warranty Australia Telephone: 08 8440 0888 | Fax: 08 8346 0504 International Telephone: +61 8 8440 0888 | Fax: +61 8 8346 0504 All logos and images are subject to relevant trademark and copyright protection Lightforce Pty Ltd. Copyright © 2018. Data and specifications contained maybe subject to change without notice.
