Installation Guide

4
DIY HARNESS INSTALLATION KIT INSTRUCTIONS
STEP 1. MOUNT THE LIGHTS
1. Install the driving lights onto a suitable mounting
surface
2. Remove the nyloc nut and M10 washer from M10
x 35mm bolt attached to the bottom of mounting
bracket
3. Locate the bracket in a suitable position
using the M10 x 35mm bolt. It is
recommended that the base area of the mounting
bracket is totally supported
4. Align the light to preferred driving position
5. Fit the washer and M10 nyloc nut, then tighten using
a 17mm socket and ratchet to specied torque
(35Nm). Do not use rattle guns
6. Tighten 2 x M10 x 35 side bolts to
recommended torque (35Nm).
WIRING HARNESS INSTALLATION
STEP 2. INSTALL THE RELAY AND CONNECT
THE LIGHTS
1. Remove the main ground wire from the negative
battery terminal. WARNING: This may result in loss of
radio security code and clock settings. Please consult
your owner’s manual before disconnecting
2. Mount the 40 amp relay (see gure 1) in a suitable
place within the engine bay, using the screw supplied
(gure 2) and your drill with a Phillips head driver bit.
Ensure that the red (positive) and black (negative) ring
terminals reach the appropriate battery terminals.
DO NOT CONNECT TERMINALS TO THE BATTERY AT
THIS STAGE
3. Route the insulated sleeved wires that run from the
relay to the driving light connectors to each of your
installed Striker LED Driving Lights and connect the
driving light connectors to the back of each light.
Ensure that cables do not touch the radiator or come
in contact with any sharp edges
4. Secure all excess wire to the vehicle with cable ties
supplied.
STEP 3. CONNECT PATCH HARNESS TO
HEADLIGHT CONNECTOR
1. Select the HB3 or H4 patch harness (refer to your
vehicle’s owner’s manual and gures 4 and 5 below
to determine which is correct) and connect it to a
headlight connector on your vehicle. If your headlights
are a type other than HB3 or H4, see item 3 below.
2. Connect the high beam pickup wires on the driving
light harness to the patch harness, red to red, green
to green.
3. NOTE: if you are installing into a vehicle with
headlights that are NOT HB3 or H4, you will need to
remove the bullet terminals on the red and green high
beam pickup wires on the driving light harness (see
gure 1) and crimp each wire into a blue insulated
male spade terminals using a crimping tool. Then
clamp the provided t-taps to the high beam wires
on one of the vehicle’s headlights. Use the red or
blue t-taps depending on the wire diameter. Finally,
connect the blue insulated male spade terminals into
the t-taps on the harness.
Green
Red
Blue
Fig 5. H4 patch harness
Green
Red
Fig 4. HB3 patch harness
Headlight
connector
Headlight
connector