Manual

4
IMPORTANT NOTES
1. Before tting the stainless steel hardware, apply a small amount of anti-seize to the thread of the 35mm
mounting bolts.
2. Mounting points vary in design and load capacity. Ensure the light is within manufacturers recommended
weight specications before tment.
3. Failure to correctly mount light may cause damage to light and vehicle.
MOUNTING BRACKET
1. Remove nyloc nut and M10 washer from M10 x
35mm bolt attached to the bottom of mounting
bracket
2. Locate the bracket in a suitable position
using the M10 x 35mm bolt. It is
recommended that the base area of the mounting
bracket is totally supported
3. Align light to preferred driving position
4. Fit the washer and M10 nyloc then tighten using
a 17mm socket & ratchet to specied torque
(35Nm)- do not use rattle guns.
5. Tighten 2 x M10 x 35 side bolts to
recommended torque (35Nm).
VENOM LED & GENESIS LED
INSTALLATION INSTRUCTIONS