Installation Guide

2
USER INSTRUCTIONS LIGHTFORCE.COM
DIY HARNESS INSTALLATION KIT
CONTENTS
• 1 x Driving light harness
• 1 x HB3 patch harness
• 1 x H4 patch harness
• 1 x Switch loom (dual switches)
• 1 x Screw for relay installation
• 2 x T-taps for wires (2 sizes)
• 4 x Spade terminals (2 sizes)
• 15 x Cable ties
• 1 x User instructions.
TOOLS AND CONSUMABLES REQUIRED
• Spanner
• Pointy nose pliers
• Wire cutters
• Phillips head driver bit
• Flashlight (recommended)
• Torque wrench (recommended).
TOOL REQUIRED FOR
NON-STANDARD INSTALLATIONS
• Crimping tool.
PERSONAL SAFETY WARNING
WARNING: High intensity light source.
Do not look directly into the light during operation,
eye injury may result.
Visit lightforce.com/installations to view
instructional videos.
NOTE: If you are using a different switch with
dash illumination (not included), a Lightforce
Switch Adaptor (not included, see Figure 9) will
be required. Follow the instructions included with
the Lightforce Switch Adaptor. The yellow dash
illumination cable (item 10 in gure 1) will need to
be wired to the dash light / park light.