Installation Guide

Installation Instructions
2. Using a level,
mark off a horizon
tal
line, and ensure
that the ends of the brackets are spaced to the width
between the
inner edges of the
vertical aluminium
extrusions (see
illustration 1). Mark off the holes using a pencil.
3. Note: Screws supplied are only suitable for stud
walls. For drywall walls use special wall fasteners,
available from DIY or hardware stores. Seek advice from
a specialist about the suitability of screws to be used.
Drill the required holes and insert wall screws.
4. Screw the
bracket to
the wall using the
screws provided.
Please ensure the
screws are fully tight
but take care not to
overtighten.
5. Before making
any electrical con-
nections it is necessary to turn off the main electricity sup-
ply. This unit is provided with a supply cable already fit-
ted. This cable should be fitted to the household lighting
circuit or to a fused 3 AMP supply. Connections should
be made in accordance with the latest regulations. This
cabinet is manufactured to CLASS 1 and requires an
earth connection.
Illustration 1
Release Leve
Example
Moments
LED ILLUMINATED MIRROR
125 Rt. 61 Schuylkill Haven, PA 17972
1-800-360-1585 • fax [phone] • [e-mail]
www.ltlhomeproducts.com
Clock unit
IR Sensor
Adjust time
OPERATING INSTRUCTIONS
•
To turn ON or OFF the LEDs, wave the hand across the IR sensor
CHANGE LIGHT INTENSITY
• Hold the hand in front of the IR sensor, while the mirror lights are ON, until
desired brightness is achieved.
CHANGE LIGHT COLOUR
• Switch OFF the LEDs and then hold the hand in front of the IR sensor. The
mirror will cycle through the colour range.
• Restart by waving the hand across the sensor at preselected colour and
intensity settings.
Time setting
touch the button to adjust the hour and wait for three seconds for hour to
be stored and the digit of minute start flashing, touch the button for three
seconds to adjust the minute and wait for three seconds to complete the
time setting.
Holding the button for three seconds,the digit of hours will start flashing,
1. Remove the packaging careully, do not lose the screws