Installation Guide

- The volume on your device is muted or turned down.
- There is a problem with the Bluetooth
®
connection - try erasing the connection on the audio device and then re-pairing.
- There may be interference from other nearby Bluetooth
®
enabled devices - try turning them o.
- The connected devices are too far apart and out of range - try moving the devices closer together.
®
-The mirror may not be in pairing mode – to do this turn the rocker switch on located on the underside of the mirror.
The indicator light located on the inside lower right hand side will ash quickly to conrm pairing mode.
- The Bluetooth
®
capability of your chosen device is turned o or out of range.
- There was a problem during pairing - some devices will pair automatically when selected some will require a pass code
or acceptance of the connection before they will nalise the pairing.
- Refer to your Bluetooth
®
device’s instruction manual to ensure it supports the A2DP (stereo Bluetooth
®
) prole.
- If attempting to connect to a PC or Mac computer, ensure that your cabinet is set as the audio output device within the
audio settings menu of the device. You may need to play a track to nalise the
connection.
- Your Bluetooth
®
device may be close to being out of range and should be moved closer to the mirror.
- For those devices that support the use of Applications, there may be too many running in the background which can
aect the amount of internal resources available on the device to transmit audio. Closing any non-essential applications
may improve audio quality.
- Similarly, if the selected device has Wi-Fi capabilities, turning this o may improve audio quality.
- There could have been a problem during the initial pairing of devices. Erase the connection using your Bluetooth
®
device and re-pair.
- For those devices with in-built sound equalisation, adjusting these settings can greatly improve the sound quality of any
audio played through your mirror.
®
- The mirror will automatically reconnect with paired devices when both devices Bluetooth
®
capabilities are turned on.
Depending on the manufacturer of the Bluetooth
®
device, the order in which the devices are turned on to automatically
connect may vary. In some cases it will be necessary to turn on Bluetooth
®
capabilities on the audio device before
turning on the cabinet.
When the Bluetooth
®
module is turned o it enters a shutdown procedure that takes between 10-30 seconds, if this
sequence is interrupted by turning the module back on during this shutdown process a software conict may occur.
During a software conict the Bluetooth
®
module will become unresponsive. To reboot the module turn o the
Bluetooth
®
module using the rocker switch and allow to stand for 10 minutes. Normal functionality will resume after this
time. To avoid software conicts always leave10-30 seconds between turning the Bluetooth
®
module o and back on
again.
There is no sound from my MIRROR
I cannot pair the MIRROR with my Bluetooth device
The sound quality is poor
My Mirror is not automatically reconnecting with my Bluetooth device
I turned the Bluetooth on-off-on and now I can't pair my device
®
Installation Instructions
LED ILLUMINATED MIRROR
Zip
125 Rt. 61 Schuylkill Haven, PA 17972
1-800-360-1585 • fax [phone] • [e-mail]
www.ltlhomeproducts.com