Installation Guide

LED ILLUMINATED ALUMINIUM CABINETS
Installation Instructions
Paseo
ELECTRICAL SAFETY INSTRUCTIONS
All connections must be installed by a licensed
electrician, in accordance with current building codes.
Consult a qualified electrician.
IMPORTANT
Always switch off the electrical supply at the main
during installation and maintenance. It is
recommended that the circuit breaker is switched off
for the necessary circuit before installation
commences.
Fitting in Bathrooms is subject to the appropriate
building code Regulations. This product is NOT
suitable for outside zones. It is also Not suitable for
installation in saunas, steam rooms or shower
cubicles. This product is only suitable for permanent
installation. DO NOT connect to a trailing plug
and socket outlet. This product is only suitable for
indoor use. Do not attach the product to surfaces that
are damp or otherwise electrically conductive.
IMPORTANT
The product must be
installed with a minimum
distance of 6” between
the infrared sensor and
an adjacent wall or
obstruction to ensure
correct function of
the sensor.
(See diagram A)
DO NOT strike glass
components with hard or
pointed items. DO NOT
place very hot or very
cold items against or in
close proximity to glass
surfaces unless an
adequately thick
insulation material is
Diagram A
INSTALLATION CARE & SAFETY
Wear suitable eye protection when drilling. Take care
when using power tools. Beware of hidden cables or
pipes. Take care if drilling on tiled surfaces in case the
drill slips. A piece of masking tape applied to the wall
before marking out the fixing holes will stop the drill
from wandering.
used to prevent such items coming in contact with
the glass. The nominal thickness of the mirror glass
used in this product is 1/4” and is film backed for
safety. If the glass becomes chipped or broken
replace immediately.
CLEANING
It is recommended that the unit is cleaned with a soft, dry, non
abrasive cloth when turned off. Never use cleaning agents or
abrasive materials on any type of surface finish. Do not allow
moisture to come into contact with the electrical components.
125 Rt. 61 Schuylkill Haven, PA 17972
1-800-360-1585 • fax [phone] • [e-mail]