Installation Guide

LED ILLUMINATED ALUMINIUM CABINETS
Installation Instructions
Vienna
125 Rt. 61 Schuylkill Haven, PA 17972
1-800-360-1585 • fax [phone] • [e-mail]
www.ltlhomeproducts.com
There is no sound from my Cabinet
- The volume on your device is muted or turned down.
- There is a problem with the Bluetooth
®
connection - try erasing the connection on the audio device and then re-pairing.
- There may be interference from other nearby Bluetooth
®
enabled devices - try turning them off.
- The connected devices are too far apart and out of range - try moving the devices closer together.
I cannot pair the Cabinet with my Bluetooth
®
device
-The cabinet may not be in pairing mode – to do this turn the rocker switch on located on the underside of the cabinet.
The indicator light located on the inside lower right hand side will flash quickly to confirm pairing mode.
- The Bluetooth
®
capability of your chosen device is turned off or out of range.
- There was a problem during pairing - some devices will pair automatically when selected some will require a pass code
or acceptance of the connection before they will finalise the pairing.
- Refer to your Bluetooth
®
device’s instruction manual to ensure it supports the A2DP (stereo Bluetooth
®
) profile.
- If attempting to connect to a PC or Mac computer, ensure that your cabinet is set as the audio output device within the
audio settings menu of the device. You may need to play a track to finalise the
connection.
The sound quality is poor
- Your Bluetooth
®
device may be close to being out of range and should be moved closer to the cabinet.
- For those devices that support the use of Applications, there may be too many running in the background which can
affect the amount of internal resources available on the device to transmit audio. Closing any non-essential applications
may improve audio quality.
- Similarly, if the selected device has Wi-Fi capabilities, turning this off may improve audio quality.
- There could have been a problem during the initial pairing of devices. Erase the connection using your Bluetooth
®
device and re-pair.
- For those devices with in-built sound equalisation, adjusting these settings can greatly improve the sound quality of any
audio played through your cabinet.
My Cabinet is not automatically reconnecting with my Bluetooth
®
device
- The Cabinet will automatically reconnect with paired devices when both devices Bluetooth
®
capabilities are turned on.
Depending on the manufacturer of the Bluetooth
®
device, the order in which the devices are turned on to automatically
connect may vary. In some cases it will be necessary to turn on Bluetooth
®
capabilities on the audio device before
turning on the cabinet.
I turned the Bluetooth
®
on-off-on and now I can't pair my device
When the Bluetooth
®
module is turned off it enters a shutdown procedure that takes between 10-30 seconds, if this
sequence is interrupted by turning the module back on during this shutdown process a software conflict may occur.
During a software conflict the Bluetooth
®
module will become unresponsive. To reboot the module turn off the
Bluetooth
®
module using the rocker switch and allow to stand for 10 minutes. Normal functionality will resume after this
time. To avoid software conflicts always leave10-30 seconds between turning the Bluetooth
®
module off and back on
again.