Installation Guide

LED ILLUMINATED ALUMINIUM CABINETS
Installation Instructions
Vienna
1. Remove the packaging taking special care with the
doors and separate shelves. Open the cabinet doors
and remove the screws on the doors. Take care not to
lose the screws.
2. Using a level,
mark off a horizon-
tal line approxi-
mately 2¾” below
where the top of
the cabinet is to be.
Position the bracket
hole so that they
are centred on the
line, and ensure
that the ends of
the brackets are
spaced to the
width between the
inner edges of the
vertical aluminium
extrusions (see
illustration 1). Mark off the holes using a pencil.
3. Note: Screws supplied are only suitable for stud
walls. For drywall walls use special wall fasteners,
available from DIY or hardware stores. Seek advice from
a specialist about the suitability of screws to be used.
Drill the required holes and insert wall screws.
4. Screw the
bracket to
the wall using the
screws provided.
Please ensure the
screws are fully tight
but take care not to
overtighten.
5. Before making
any electrical con-
nections it is necessary to turn off the main electricity sup-
ply. This unit is provided with a supply cable already fit-
ted. This cable should be fitted to the household lighting
circuit or to a fused 3 AMP supply. Connections should
be made in accordance with the latest regulations. This
cabinet is manufactured to CLASS 1 and req
uires an
earth connection.
6. When the cabinet is fully secure the internal top cover
should be closed and secured with the small screws
removed earlier. When the cover is closed and secure
restore the
main power and test the function of the lights and
the shaver socket. If the light fails to function properly it is likely
the IR sensor has been positioned too close to an adjacent wall
or reflective surface
to overtighten). Shelves can
be positioned accordingly by sliding the supports up or
down (NOTE: Take care to use both hands when sliding
shelves and ensure thatsupport brackets at both ends
slide simultaneously). Once shelves are in their desired
locations turn screw D to secure in position. A level
should be used to ensure shelves are level.
9. If the doors are out of alignment first remove the soft-
close buffer (from the relevant hinges) which clips into
the main hinge plate. The soft-close hinges offer
adjustment in 3 directions via adjustment screws
E,F and G (see diagram).
E
G
Release Lever
Illustration 1
Release Lever
Example 2
C
D
Example 2
C
D
E
E
F
G
Release Lever
E
Release Lever
E
F
G
Release Lever
Fitting the glass shelves.
Firstly insert a shelf into the
top two shelf support brack-
ets then slide upwards so the
grub screws on the under-
side of the support brackets
(Screw C) can be sufficiently
tightened to hold glass in
place. Repeat for the bottom
shelf (NOTE: be careful not
7.
125 Rt. 61 Schuylkill Haven, PA 17972
1-800-360-1585 • fax [phone] • [e-mail]
www.ltlhomeproducts.com
OPERATING INSTRUCTIONS
Light can be controlled by using the IR sensor switch under the cabinet