User Manual

OWNER’S MANUAL
* The light will run at full power off external external source as long as
1- the battery is charged to 60% or more
2- power supply minimum 110Watt
Light will operate best on external power if internal battery is charged
60% or more. If the light is run off wall power with an empty battery,
the extra heat generated while charging may reduce the output.
OPERATING FROM EXTERNAL POWER
OPERATING THE CLx WITH
SOFTBOXES
When using 3rd-Party modifers that cover
the heat sink, trapped heat can cause
the light to lower it’s output. To prevent
overheating, open the modifier vents or
dial back to a lower lumen output.
MENU DISPLAY
OPERATION SPECIFICATION
DETAILED OPERATIONS
AUTO FAN OPERATION
Auto fan behavior
0-4000 lumens - fan off
4000+ to 6400 lumens - fan low
over 6400 lumens - fan high
charging - fan low
MENU SCREEN
• Long press of middle button access /exits menu
• Short press of front/rear button adjusts the
selected option up/down.
• Short press of middle button advances to
the next option (i.e. if the group setting was
selected, it would advance the frequency. The
selected option blinks slowly so you know which
one is active).
• After 20sec pass without a button press, the
menu screen will exit.
OPERATION
OFF
ON
Power Knob
MODE
Short Press = Step Increase/Decrease
Long Press = Smooth Increase /
Decrease Output
Short Press = ON/OFF
Long Press = Menu Settings
RF ON/OFF
Group (1-4)
Frequency /Channel (1-20)
/
/
/
Percentage / Lumen Output
External Power Supply Wattage
Lm
60w110w
110w
Power Supply
YS MOUNT W/
UMBRELLA HOLDER
• FLAT PORT DM
CSTAND MOUNT
HIGH LEVERAGE
HANDLE
THUMB SCREW
INCLUDED MODIFIERS
INCLUDED
MOUNTS
Light & Motion
711 Neeson Road,
Marina, CA 93933 USA
[e-mail]
lightandmotion.com
Must be on to charge
ELINCROM MODIFIER
MOUNT
Short Press: Moves Up
Short Press: Cycles through settings
Long Press: Enter / Exit
Short Press: Moves Down
MENU CONTROLS
Thermal Sensor is not Detect
Return unit to Light and Motion for
servicing.
Overheating Icon
Wait to charge until
symbol disappears
LED is not detected
Battery Status
Light Operating With
External Power
Lumen/Percentage Output
8000/5000
POWER
LUMENS
MIN
90
LED
8000
External Power Detected
Overheating icon
OLED DISPLAY
CARE & MAINTENANCE
• Maintain o-rings with a light coating of silicone grease to preserve seal.
• Clean charge terminals with rubber pencil eraser or cotton-tipped or foam-tip
swab with vinegar/water solution.
STORAGE & TRAVEL
• Never store the lights with the batteries fully discharged as this may cause
permanent damage to the batteries.
• Store your light partially to fully charged for long life.
• Do not leave lights in direct sun or stored in hot location.
• Turn power switch off for travel.
• Always operate the CLx with a DM modifier installed to protect the LED from dust
and moisture.