Installation Guide

Installing The Light
1 Slide the mounting plate off the back of the Porch Light (see illustration below).
2 Making sure that the arrows on the mounting plate are pointed upwards,
securely fasten it to the wall or other stable surface using 2 wood screws (included).
3 Please note that it is generally recommended to drill pilot holes prior to fastening
the screws. In some cases, special fasteners for surfaces such as drywall, cement,
or brick may be required.
4 Slide the knob on the back of the Porch Light into the slot on the mounting plate.
5 Adjust the light and sensor as needed by swiveling it on the mounting plate
and/or rotating the light head.
SPECIFICATIONS
Batteries: 4 C cell alkaline or Ni-mh
Voltage: 6V DC
Light Duration: 30 +/- 4 seconds
Detection Angle: 100˚ cone
Max Detection Distance: 25 feet
ATTENTION
To avoid damage to the electrical components, please observe the following
precautions:
Do not aim the sensor directly towards the sun.
Do not shake or drop the light.
Do not expose the light to static electricity.
Please note that circuit requires 90 seconds to stabilize after the
batteries are inserted.