Installation Instructions

3 - USE OF THE SENSOR
3.1
DESCRIPTION OF THE SENSOR
Sensor for automatic control of door movement to send a switch-on command
to a compatible receiver.
To be able to use the sensor you must first carry out the learning procedures on the receiver (see paragraph 4).
SENSA T - SENDING A COMMAND TO A DEVICE:
IWhen the sensor sees a movement, it sends a command to switch on the light to the receiver it is associated with.
Switching off is carried out through a timer in the receiver (see receiver manual).
SENSA M (with magnet present) - SENDING A COMMAND TO A DEVICE:
When the door is opened or a movement is detected, the sensor sends a command to switch on the light to the receiver it is
associated with.
Switching off is carried out when the door is closed and/or with a timer in the receiver (see receiver manual).
3.2 USE OF SENSOR
PROCEDURE:
4.1 PROGRAMMING THE SENSOR WITH THE ASSOCIATION OF
THE SERIAL NUMBER
4 - PROGRAMMIMNG
To be able to use the sensor you must first carry out the learning procedures on the receiver
Default: unique factory code, manual association required.
STEP 1
Hold the sensor button down.
The led turns on and
change color cyclically
STEP 2:
Take your finger off the button when the LED comes
on in the colour corresponding to the output with
which the sensor is to be associated.
EXAMPLES:
STEP 4
Press the button on the sensor
for a short time during the flash
that corresponds to the serial
number desired to end
the count.
If you take your finger off on
red, the sensor will make
LIGHT1 turn on.
If you take your finger off on
green, the sensor will make
LIGHT1 turn on.
If you take your finger off on
blu, the sensor will make
LIGHT1 turn on.
If you take your finger off on
yellow, the sensor will make
LIGHT1 turn on.
NOTE:
Make a note on the label of the "serial number" and
the output the sensor was associated with, for any
future maintenance work.
ON
1 2 3 4
Num.
LIGHT1
red
led
green
led
blu
led
yellow
led
LIGHT2
ON
1 2 3 4
Num.
ON
1 2 3 4
Num.
LIGHT3
Num. Out.
ON
1 2 3 4
Num.
LIGHT4
5 1
STEP 3:
The LED stays on in the colour selected.
Press the button on the sensor for a short time and
count the number of flashes emitted by the LED:
FLASH SERIAL NUMBER
1 flash 1
2 flashes 2
3 flashes 3
4 flashes 4
5 flashes 5
6 flashes 6
7 flashes 7
8 flashes 8
9 flashes 9
10 flashes 10
11 flashes 11
12 flashes 12
13 flashes 13
14 flashes 14
15 flashes 15
16 flashes 16
17 flashes 17
18 flashes 18
19 flashes 19
20 flashes 20
21 flashes Unique factory code,
carry out manual association
(see paragraph 4.2)
www.lightengineer ing.net
www.lightengineer ing.net