Cut Sheet
03.17.20 Information is subject to change without notice.
LIGHT EFFICIENT DESIGN HEADQUARTERS 188 S. Northwest Highway • Cary, IL 60013
INNOVATION & MANUFACTURING CENTER 30 Log Bridge Road, Building 200 • Middleton, MA 01949
847.380.3540 • led-llc.com
SENSOR KIT FOR LEDBARKIT - INTERNAL DRIVER (LBI)
RP-LBI-OC2
PERMANENT ON FUNCTION
Press ‘ON’ button, xture goes to permanent on mode, sensor is disabled.
With memory function against power failure.
*
Press ‘Auto’ or ‘Reset’ to quit this mode.
PERMANENT OFF FUNCTION
Press ‘OFF’ button, xture goes to permanent off mode, sensor is disabled.
*
Press ‘Auto’or ‘Reset’ learn’ to quit this mode.
SENSOR MODE
Press ‘Auto’ button, the sensor starts to work and all settings remain the
same as the latest status before the light was switched on/off.
RESET FUNCTION
Press ‘Reset’ button, all settings go back to factory default settings.
FACTORY DEFAULT SETTINGS - REMOTE REQUIRED TO CHANGE SETTINGS
Sensitivity=50%
Daylight sensor=disable
Hold time=5min
Twilight time=+∞
Twilight level=30%
NOTE daylight harvest function is disabled in factory defaut mode. Choose
the appropriate lux threshold rst to activate the daylight harvest
function.
DISABLE DAYLIGHT SENSOR
Press ‘Disable’ button, the daylight sensor will be disabled, the motion
sensor will work always, even in daytime.
TEST MODE
‘Test mode’ is used for testing purpose only, for users to check the the de-
sired detection range.
Quit test mode by pressing any other button of ‘Hold time’. The sensor
settings are changed accordingly.
TEST MODE SETTINGS
Daylight sensor=disable
Hold time=3s
Twilight time=N/A
Twilight level=N/A
•
The buzzer short beeps (~0.5s)
ONCE when sensor successfully
receives RC signal after pressing any
button.
•
When“twilight level”set at 0%, it
becomes ON/OFF control.
•
The sensor controls the LBI xtures
w/ 0-10V inputs. Even if on/off only
function is desired, the OC2 sensor
is only compatible w/ PRO series LBI
products. (Not compatible w/ LBI
Base series)
Remote Control Settings
IR11
If satised with OC2 default settings, remote control is not needed. If settings need to be changed, optional remote control
(RP-OC2-REMOTE-IR11), is required.
PAGE 18