Installation Guide
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de
l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d’en compromettre le fonctionnement.
Radiation Exposure Statement
This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment.
Déclaration d’exposition aux radiations
Cet équipement est conforme aux limites d’exposition aux rayonnements IC
établies pour un environnement non contrôlé.
CHANGES & MODIFICATION
Changes or modifications made to this device may void certification of the
device. Changes or modifications made to this unit not expressly approved by
the party responsible for compliance could void the user‘s authority to operate
the equipment.
RECOMMENDED INSTALLATION REQUIREMENTS
This device should only be installed in light fittings and fixtures that are designed
to accept each fitting. Lamps, fittings and fixtures that are designed to accept
smaller or lower wattage light bulbs may result in the LIFX® bulb operating below
its optimal capacity. For optimal performance it is recommended that LIFX® bulbs
be fitted into fixtures that provide sucient air flow through and around the bulb.
It is recommended that the LIFX® bulb be installed away from other devices
designed to receive or transmit radio signals. It is recommended LIFX® bulb/s
be installed and operated at a minimum distance of 30 cm from the body.
For lamps with a weight significantly higher than that of lamps for which they are
a replacement, attention should be drawn to the fact that the increased weight
may reduce the mechanical stability of certain luminaires and may impair contact
making and lamp retention.
INTERFERENCE
LIFX® has been designed to minimise interference with other radio, broadcast
or receiving devices. The manufacturer is not responsible for any interference
caused as a result of modifications to the product or by failure to adhere to the
recommendations in this document and at support.lifx.com. This device generates
radio frequency energy and, if not installed in accordance with the “recommended
installation requirements” may cause harmful interference to radio communication
devices. If the device is causing radio interference it is recommended that the
user try:
a) relocating the device to a dierent place;
b) adjust the antenna on the receiving device;
c) consult a technician experienced in radio interference.