Full Product Manual

This equipment complies with IC radiation
exposure limits set forth for an uncontrolled
environment.
Déclaration d’exposition aux radiations
Cet équipement est conforme aux limites
d’exposition aux rayonnements IC établies pour
un environnement non contrôlé.
Changes & modification
Changes or modifications made to this
device may void certification of the device.
Changes or modifications made to this unit not
expressly approved by the party responsible for
compliance could void the user‘s authority to
operate the equipment.
Frequency Information
Frequency Range (Europe & Australia):
2412-2472 MHz; Maximum radio-frequency
power transmitted: 18.75 dBm;
Modulation type : IEEE 802.11 b/g/n20
Installation requirements
& recommendation
This device should only be installed in light
fittings and fixtures that are designed to
accept each fitting. Lamps, fittings and fixtures
that are designed to accept smaller or lower
wattage light bulbs may result in the LIFX® bulb
operating below its optimal capacity. For optimal
performance it is recommended that LIFX®
bulbs be fitted into fixtures that provide sucient
air flow through and around the bulb. It is
recommended that the LIFX® bulb be installed
away from other devices designed to receive or
transmit radio signals. It is recommended LIFX®
bulb/s be installed and operated at a minimum
distance of 30 cm from the body. For lamps with
a weight significantly higher than that of lamps
for which they are a replacement, attention
should be drawn to the fact that the increased
weight may reduce the mechanical stability
of certain luminaires and may impair contact
making and lamp retention.
Interference
LIFX has been designed to minimise interference
with other radio, broadcast or receiving devices.
The manufacturer is not responsible for any
interference caused as a result of modifications
to the product or by failure to adhere to the
recommendations in this document and at
support.lifx.com. This device generates radio
frequency energy and, if not installed in
accordance with the “recommended installation
requirements” may cause harmful interference
to radio communication devices. If the device is
causing radio interference it is recommended
that the user try:
a. relocating the device to a dierent place;
b. adjust the antenna on the receiving
device;
c. consult a technician experienced in radio
interference.
Notices
• Installers should examine all parts that are
not intended to be replaced by the retrofit kit
for damage and replace any damaged parts
prior to installation of the retrofit kit.
• This device is not intended for use with
emergency exits
• Use in open luminaire only
• Only use the control provided with or specified
by these instructions to control this lamp.
This lamp will not operate properly when
connected to a standard (incandescent)
dimmer or dimming control.
LIFX® is not designed for use in:
• Excessively hot environments (e.g. close to
ovens, radiators, heaters, etc.)
• Regions or countries other than that in which
the product was intended for
• Outdoor and wet areas, except where the
LIFX®Product specifies that it is for both
Indoor and Outdoor use.
When using LIFX
• Switch o the power supply to the socket
and allow sucient time for the bulb to cool
before removing a LIFX bulb from the fitting
• Do not open device, as this will void the
warranty
• Do not clean the device when it is powered on
and or connected to the light socket
• If cleaning the product, use a soft dry cloth,
do not use cleaning agents
Limited Warranty
General
Feit Electric Co (“LIFX“) warrants the LIFX
bulb (the “Product“), and only the Product,
against defects in materials and workmanship
under normal use (“Defect”) for a period of
TWO YEARS (730 days) from the date of retail
purchase by the original purchaser (“Warranty
Period“). Under this Limited Warranty, if a
defect arises and a valid claim is received by
LIFX® within the Warranty Period, at its option
and to the extent permitted by law, LIFX will
either: 1. repair the Product at no charge,
using new or refurbished replacement parts
--or-- 2. exchange the Product with a new or
refurbished Product.
In the event of a defect, to the extent permitted by
law, these are your sole and exclusive remedies.
A replacement Product or part assumes the
remaining warranty of the original Product or
ninety (90) days from the date of replacement
or repair, whichever is longer. When a Product
or part of the Product is exchanged, any
replacement item becomes your property and
the replaced item becomes LIFX‘s property. Parts
provided by LIFX in fulfilment of its warranty
obligation must be used in Products for which
warranty service is claimed.
Exclusions & Limitations
This Limited Warranty applies only to the
Product manufactured by or for LIFX that can be
identified by the “LIFX trademark, trade name,
or logo axed to it. The Limited Warranty does
not apply to any (a) LIFX products and services
other than the Product, (b) non- LIFX hardware
product, (c) consumables (such as batteries),
or (d) software, even if packaged or sold with
the Product or embedded in the Product. Refer
to the licenses accompanying the software
for details of your rights with respect to its use.
LIFX does not warrant that the operation of the
Product will meet your needs or requirements
or be uninterrupted or error free. LIFX is not
responsible for damage arising from failure to
follow instructions relating to the Product‘s use or
from failures resulting from inadequate electrical
supply or internet access. This warranty does
not apply to a Product or part of the Product
that has been altered or modified (e.g. to alter
functionality or capability) by anyone who is
not a representative of LIFX or if the Product is
inserted or installed in a casing not provided by
LIFX. In addition, this Limited Warranty does not
apply to Defects or damage caused by (a) use
with non-LIFX products; (b) accident, abuse,
misuse, flood, fire, earthquake or other external
causes or abnormal conditions; (c) operating the
product outside the permitted or intended uses
or conditions described by LIFX or with improper
voltage or power supply; or (d) service (including
upgrades and expansions) performed by anyone
who is not a representative of LIFX. Recovery and
reinstallation of software programs and user
data are not covered under this Limited Warranty.
This Limited Warranty does not cover the cost
of returning the Product to LIFX; this is your
responsibility. No LIFX reseller, agent, or employee
is authorized to make any modification, extension,
or addition to this Limited Warranty. If any term is
held to be illegal or unenforceable, the legality or
enforceability of the remaining terms shall not be
aected or impaired.
EXCLUSIVE WARRANTIES
THE WARRANTIES SET FORTH HEREIN ARE THE
EXCLUSIVE WARRANTIES PROVIDED BY LIFX,
AND EXCEPT TO THE EXTENT PROHIBITED BY
APPLICABLE LAW, ALL OTHER WARRANTIES,
WHETHER EXPRESS OR IMPLIED WARRANTIES
(INCLUDING WARRANTIES OF MERCHANTABILITY,
FITNESS FOR A PARTICULAR PURPOSE AND NON
INFRINGEMENT) ARE HEREBY EXCLUDED.
LIMITATION OF DAMAGES
EXCEPT TO THE EXTENT PROHIBITED BY
APPLICABLE LAW, LIFX SHALL NOT BE LIABLE
FOR ANY INCIDENTAL, INDIRECT, SPECIAL,
OR CONSEQUENTIAL DAMAGES RESULTING
FROM ANY USE OF THE PRODUCT OR BREACH
OF EXPRESS OR IMPLIED WARRANTY OR
CONDITION, OR UNDER ANY OTHER LEGAL
THEORY. LIFX’S LIABILITY FOR DAMAGES
RESULTING FROM ANY USE OF THE PRODUCT
OR BREACH OF EXPRESS OR IMPLIED
WARRANTY OR CONDITION, OR UNDER
ANY OTHER LEGAL THEORY WILL BE
LIMITED TO THE ORIGINAL COST PAID FOR
OF THE DEFECTIVE PRODUCT.
Consumer Protection
Some states do not allow the exclusion or
limitation of incidental or consequential
damages, or allow limitations on how long
an implied warranty lasts, so the above
limitations or exclusions may not apply to
you. This warranty gives you specific legal
rights, and you may also have other rights
that vary by state to state.
Governing Law and Arbitration
This Limited Warranty shall be governed
by the laws of the State of California
without giving eect to any conflict of
laws principles that may provide the
application of the law of another jurisdiction
and without regard to the Convention
on Contracts for the International Sale of
Goods. Any claim or dispute in connection
with this Limited Warranty shall be resolved
in a cost eective manner through binding
non appearance based arbitration. The
arbitration shall be initiated through an
established alternative dispute resolution
provider mutually agreed upon by the
parties. The alternative dispute resolution
provider and the parties must comply with
the following rules: a) the arbitration shall
be conducted by telephone, online and/
or be solely based on written submissions,
the specific manner shall be chosen by
the party initiating the arbitration; b) the
arbitration shall not involve any personal
appearance by the parties or witnesses
unless otherwise mutually agreed by the
parties; and c) any judgement on the award
rendered by the arbitrator may be entered
in any court of competent jurisdiction.
If the foregoing arbitration clause does
not apply for any reason, you agree to
submit to the personal jurisdiction of the
state courts located within San Francisco
County, California and the federal courts
in the Northern District of California for
the purpose of litigating all such claims or
disputes, which courts shall have exclusive
jurisdiction of such claims or disputes.
Notwithstanding the foregoing, LIFX may
seek injunctive or other equitable relief to
protect its intellectual property rights in any
court of competent jurisdiction.
FEIT ELECTRIC CO. is the
exclusive owner of rights
and interests in and to the
mark LIFX and the LIFX logo.
Covered by patents.
lifx.com/patents
© 2022
All rights reserved.
For more information visit lifx.com
Product Dimensions
(LxWxH) :
7.45 x 7.45 x 2.5 in
Wi-Fi 802.11 b/g/n
120V - 60Hz
Product Details
I’ve set up a new network / changed my password,
how do I re-connect my lights ?
If you’ve changed your Wi-Fi password or set up a
new router with a new password, you will need to
reset your lights and connect them through the app
as you did the first time you connected them. This is
so you can assign the new, correct password for the
security of each device.
How do I connect other devices and services like
Voice control or IFTTT ?
This can vary depending on the service you’d like to
use. You can find out about major partner products
LIFX work well with at LIFX.com. For advice on
connecting services you can find instructions for
these at go.LIFX.com
Need more help?
Visit the LIFX Help Center at support.lifx.com
Connectivity, setup and troubleshooting
FCC Compliance
Statement U.S.
This equipment has been tested and found
to comply with the limits for a Class B digital
device, under Part 15 of the FCC Rules. These
limits provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate
radio frequency energy and, if not installed
and used under the instructions, may interfere
with radio or television reception, which can
be determined by turning the equipment o
and on. The user is encouraged to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the
equipment and the receiver
• Connect the equipment into an outlet on a
circuit dierent from that to which the receiver
is connected
• Consult the dealer or an experienced radio/TV
technician for help
Changes or modifications not approved by
LIFX can void the user’s authority to operate
the equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
Regulations &
Compliance.
may cause undesired operation. Contains FCC
ID: 2AA53-LCM3
Industry Canada Compliance.
LIFX complies with all applicable Industry
Canada Standards. This Class B RFLD complies
with the Canadian standard ICES-005. Contains
IC: 11475A-LCM3. See www.lifx.com/compliance
RF exposure warning (Industry Canada)
This equipment must be installed and operated
in accordance with provided instructions and
the antenna(s) used for this transmitter must
be installed to provide a separation distance
of at least 20 cm from all persons and must not
be co-located or operating in conjunction with
any other antenna or transmitter. End-users
and installers must be provided with antenna
installation instructions and transmitter
operating conditions for satisfying RF exposure
compliance.
This device complies with Industry Canada
license-exempt RSS standard(s). Operation
is subject to the following two conditions: (1)
this device may not cause interference, and
(2) this device must accept any interference,
including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR
d’Industrie Canada applicables aux appareils
radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes : (1)
l’appareil ne doit pas produire de brouillage,
et (2) l’utilisateur de l’appareil doit accepter
tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le
fonctionnement.
Radiation Exposure Statement
What type of Wi-Fi do I need ?
Like many devices, LIFX lights connect to the 2.4Ghz
band of Wi-Fi, not 5Ghz. If you have more than one
available network on your router, this could mean
you are connected to 5Ghz and need to try your
other network. Almost all Wi-Fi routers will have a 2.4
GHz band so if you only have one network you will
likely be on the right one to get started.
How do I reset a light to factory settings ?
Turn the light o and on at the switch 5 times, about
one switch a second (not too fast). The lights will
cycle through four colors or whites and stop on white
when the reset has been successful. This is how you
would remove a light from a network to then add it
to a new one.
FAQS