Full Product Manual
Regulations & Compliance.
FCC Compliance Statement U.S.
This equipment has been tested and found to comply with
the limits for a Class B digital device, under Part 15 of the
FCC Rules. These limits provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used under the
instructions, may interfere with radio or television reception,
which can be determined by turning the equipment o and
on. The user is encouraged to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and the
receiver
• Connect the equipment into an outlet on a circuit dierent
from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician
for help
Changes or modifications not approved by LIFX can void the
user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
Contains FCC ID: SYW-LCM4
Changes & modification
Changes or modifications made to this device may void
certification of the device. Changes or modifications made
to this unit not expressly approved by the party responsible
for compliance could void the user‘s authority to operate
the equipment.
Frequency Information
Frequency Range (US & Canada): 2412-2472 MHz;
Maximum radio-frequency power transmitted: 22.50dBm;
Modulation type: IEEE 802.11 b/g/n/ax
Installation requirements
& recommendation
This device should only be installed in light fittings and fixtures
that are designed to accept each fitting. Lamps, fittings and
fixtures that are designed to accept smaller or lower wattage
light bulbs may result in the LIFX bulb operating below its
optimal capacity. For optimal performance it is recommended
that LIFX bulbs be fitted into fixtures that provide sucient air
flow through and around the bulb. It is recommended that
the LIFX bulb be installed away from other devices designed
to receive or transmit radio signals. It is recommended LIFX
bulb/s be installed and operated at a minimum distance of 30
cm from the body. For lamps with a weight significantly higher
than that of lamps for which they are a replacement, attention
should be drawn to the fact that the increased weight may
reduce the mechanical stability of certain luminaires and may
impair contact making and lamp retention.
Interference
LIFX has been designed to minimize interference with other
radio, broadcast or receiving devices. The manufacturer
is not responsible for any interference caused as a result
of modifications to the product or by failure to adhere to
the recommendations in this document and at support.
lifx.com. This device generates radio frequency energy
and, if not installed in accordance with the “recommended
installation requirements” may cause harmful interference to
radio communication devices. If the device is causing radio
interference it is recommended that the user try:
a. relocating the device to a dierent place;
b. adjust the antenna on the receiving device;
c. consult a technician experienced in radio interference.
Notices
• This device is not intended for use with emergency exits
• Only use the control provided with or specified by these
instructions to control this lamp. This lamp will not operate
properly when connected to a standard (incandescent)
dimmer or dimming control.
LIFX is not designed for
use in:
• Excessively hot environments
(e.g. close to ovens,
radiators, heaters, etc.)
• Regions or countries other
than that in which the
product was intended for
• Outdoor and wet areas,
except where the LIFX
Product specifies that it is
for Outdoor use.
When using LIFX
• To avoid risk of shock,
always make sure the
product is unplugged from
the electrical outlet before
assembling, disassembling,
installing, relocating,
servicing or cleaning it.
• Do not open device, as this
will void the warranty
• If cleaning the product, use
a soft dry cloth, do not use
cleaning agents