Full Product Manual

Time to hook this baby up!
Clamp the provided cable to your
low voltage system wire, as you
would any other accessory lighting
product for your setup.
Connect the end to the wire
attached to the Path light.
Check you've got these nicely lined up
so the two sides fit together and screw
the cap over the join tightly to ensure
it's waterproof.
CONNECT THE WIRES
2
3
THEN...
CLOSE UP
T
W
I
S
T
M
E
Safety first...
Cautions:
• Do not secure the wiring of
the product with staples,
nails, or sharp hooks. DO
NOT DAMAGE THE WIRE.
• Do not use product for other
than its intended use.
• Do not cover the product
with cloth, paper or any
material not part of the
product when in use.
• Keep lamps away from
any combustible surface.
• Read and follow all
instructions that are on the
product or provided
with the product.
• This product should be
installed out of the reach
of children.
• Do not bury the wire more
than 6" underground.
3. Make sure all connectors
are tightly secured to
prevent water entry.
Do not submerse.
4. The instructions in this
manual are not intended
to cover every possible
installation, operation,
maintenance, or mounting
situation.
Warning:
1. To avoid risk of shock,
always make sure the
product is disconnected
from power before
assembling, disassembling,
installing, relocating,
servicing or cleaning it.
2. Do not overload. Check
that the Watts used by this
product are within the load
limit of your transformer.
IMPORTANT!
We're checking one
last time before you
clamp it: Your system
is 12V, and you have 33
Watts allowance (after
calculations for wiring)
left on the attached
transformer. Ok, great!
READ AND FOLLOW ALL
SAFETY INSTRUCTIONS
• Connect this product ONLY
to a 12V low voltage system
with appropriate Wattage
allowance available.
• Do not mount or place
near gas or electric
heaters, fireplace, candles,
or other similar sources
of heat.