User Manual

5
AUDIO FEEDBACK FROM THE UNIT:
1 Low Tone Beep = Failure
2 Two High Tone Beeps = Valid sequence
3 Low Tone Beep = Error or invalid sequence
NOTE: Use the STAR Key “*” to cancel any input.
NOTE: Keypad commands are to be entered in a single string to result in success (indicated by double high tone).
Stop and go keystrokes will result in negative tones (low single and triple fail tones).
PROGRAMMING » QUICK REFERENCE
KEYPAD PROGRAMMING
PROGRAMMING NUMBER DESCRIPTION OF TASK FACTORY SETTING PROGRAMMING PROCEDURE
1 Trigger Relay One Master Code (4 digits) + 1
2 Trigger Relay Two Master Code (4 digits) + 2
7 Delete User Code
Master Code (4 digits) + 7 + User Code that is to be deleted
(4 digits)
9 Enter User Code
Master Code (4 digits) + 9 + New User Code
(4 digits) + Relay Associated with the User Code (1 or 2)
03 Enable Intercom (No-Telco) Mode Master Code (4 digits) + 03
04 Enable Telco Mode Enabled Master Code (4 digits) + 04
06 Speaker Volume Level 2
Master Code (4 digits) + 06 + Volume Level
(1 = Low, 2 = Medium or 3 = High)
07 Microphone Sensitivity Level 2
Master Code (4 digits) + 07 + Volume Level
(1 = Low, 2 = Medium or 3 = High)
09 Change the Master Code
Master Code (4 digits) + 09 + ### + New Master Code
(4 digits)
51 Create Temporary (1 Shot) Code
Master Code (4 digits) + 51 + New Temporary (1 Shot) Code
(4 digits) + Relay Associated with the User Code (1 or 2)
(Expires after 24 hours)
52
Enable Vacation (Lock Down)
Mode
Disabled Master Code (4 digits) + 52
53
Disable Vacation (Lock Down)
Mode
Master Code (4 digits) + 53
54 Engage Party Mode (Relay 1) Disabled Master Code (4 digits) + 54
56 Engage Party Mode (Relay 2) Disabled Master Code (4 digits) + 56
021 Enable Parallel Relay Output Enabled Master Code (4 digits) + 021
023
Enable Independent Relay Output
Control
Disabled Master Code (4 digits) + 023
024 Adjust Relay Output Time (Relay 1) .5 Seconds
Master Code (4 digits) + 024 + Relay Output Time (0000-8000
Seconds) NOTE: Relay output time is ALWAYS 4 digits.
025 Adjust Relay Output Time (Relay 2) .5 Seconds
Master Code (4 digits) + 025 + Relay Output Time (0000-8000
Seconds) NOTE: Relay output time is ALWAYS 4 digits.
DIRECT COMMANDS FROM THE UNIT KEYPAD
KEYSTROKES ACTION
User Code + 1 Triggers Relay 1
User Code + 2 Triggers Relay 2