USER’S GUIDE VEHICULAR SLIDE/SWING GATE OPERATORS CSL24V ™ & CSL24VH ™ CSW24V ™ & CSW24VH ™ Your model may look different than the model illustrated in this user’s guide. Please contact your authorized LiftMaster dealer for all of your service needs. Installation Date www.liftmaster.
Thank you for purchasing a LiftMaster gate operator. Our operators are designed to meet or exceed UL325 safety standards and requirements and are quality manufactured for years of safe and reliable service. Think LiftMaster for all of your Access Control needs. OPERATION RESET SWITCH/MANUAL DISCONNECT The reset switch is located on the front of the operator and serves several functions.
OPERATION OPERATOR ALARM If a contact sensor detects an obstruction twice consecutively the alarm will sound (up to 5 minutes) and the operator will need to be reset. If a command is given after the initial 5 minutes the operator will beep. When the inherent force of the operator (RPM/current sensor) detects the following (twice consecutively) the alarm will sound (up to 5 minutes) and the operator will need to be reset: The gate is hitting a wall or vehicle. The gate does not meet specifications.
MAINTENANCE CHECK AT LEAST ONCE EVERY MONTH DESCRIPTION TASK Entrapment Protection Devices Check and test for proper operation Warning Signs Make sure they are present Gate Inspect for wear or damage Drive Chain (Slide Only) Check for excessive slack and lubricate The following should be checked by an authorized LiftMaster dealer: CHECK AT LEAST ONCE EVERY DESCRIPTION TASK Manual Disconnect Check and test for proper operation 6 MONTHS X Sprockets and Chains Check for excessive slack and lub
ACCESSORIES ENTRAPMENT PROTECTION DEVICES PHOTOELECTRIC SENSORS (NON-CONTACT) The photoelectric sensors are designed to detect an obstacle in the path of the electronic beam and stop the operator. Includes mounting brackets. Models AOMRON E3K-R10K4-NR (retro-reflective), RETROAB 60-2728 (retro-reflective), CPS-UN4 (through beam) SENSING EDGE (2-WIRE, NON-MONITORED, CONTACT) Sensing edges can detect an obstacle upon contact and stop the operator.
ACCESSORIES MISCELLANEOUS POST-MOUNTING PLATE For post-mounting commercial slide/swing operators. Posts not included. Model MPEL REMOTE ANTENNA EXTENSION KIT The remote antenna extension kit allows the antenna to be remotely installed. Model 86LM WIRELESS ACCESS CONTROL RECEIVER Access control receiver for up to 450 remote controls. Model STAR450-315 HEATER Keeps operator, gearbox and batteries at suitable temperature when outside temperature is below 0°F for extended periods of time.
ACCESSORIES VEHICLE SENSING PROBE The vehicle sensing probe is buried in the ground and can detect a car as it approaches and will then open the gate. Model CP3 SOLAR PANEL KIT - 10 WATT This kit is to replace or add a solar panel to the operator application. Up to three solar panels can be connected to the operator. Model SOLPNL10W12V (requires 2 minimum) BATTERY FOR GATE ACCESS SYSTEMS Gate access system batteries replace or upgrade the gate operator batteries.
45 Larch Avenue Elmhurst, Illinois 60126-1196 01-35591 © 2011, The Chamberlain Group, Inc.
