User Guide

Chapter 1: Installing SVWin
5
Doc 6001197, Rev D
Chapter 1: Installing SVWin
This chapter will cover . . .
 Information about this Manual
Page 5
 System Requirements
Page 5
 Installing SVWin
Page 6
 SVWin “Help” Aids
Page 7
About this Manual
The procedures in this manual assume that you have already read the manuals for your
telephone entry system (Spectrum).
System Requirements
Windows-based software offers many advantages in terms of usability and versatility, but
requires a computer configuration powerful enough for it to work effectively. While you may be
able to run SVWin on older, less powerful computers, it will run very slowly and with greater
chance of failure. For this reason we strongly recommend using at least the minimum computer
configuration. To use SVWin software, the following items are required:
A Sentex Spectrum with -101 or -301 Board connected to a telephone line.
An IBM PC-Compatible computer running Windows 95 (full version) or higher.
Internet Explorer version 4.01 (service pack 2) or later (5.0 or later recommended).
Internet Explorer is provided on the CD for your convenience.
MINIMUM RECOMMENDED REQUIRED
Pentium 166 Processor
32 MB of RAM
200 MB hard disk free
Pentium II Processor
128 MB of RAM
300 MB hard disk free
Hayes-compatible modem
connected via a COM port
CD ROM
Mouse
SVWin System Requirements
IMPORTANT NOTE
SVWin stores information about its settings in the Windows Registry. If you need to change this
information, Sentex dealers should call Sentex Systems Technical Support for assistance.