User Guide

Chapter 8: Sending Data to a Unit
33
Doc 6001197, Rev D
Chapter 8: Sending Data to a Unit
This chapter will cover . . .
 About Sending Changes
Page 33
 Sending All to a Unit
Page 34
 Sending Changes to a Unit
Page 34
About Sending Changes
In order to apply all programming changes made through SVWin, they must be sent to the
Spectrum Memory. The changes can be sent to the Spectrum Memory through the
Communicate with Unit screen (see Figure 19) or through the Schedule When to Send
Changes To All Units screen (see Figure 21 on page 38).
Figure 19: Communicate Screen
IMPORTANT NOTES:
No SVWin programming or Spectrum unit activity can take place during a send/receive
process. In addition, tenants and visitors cannot gain entry during that time.
If the directory or entry code capacities are exceeded, you will not be allowed to send
changes to units.