User Guide

Chapter 7: Managing Entry Codes 31
Doc 6001197, Rev D
The selections are as follows:
Cycle Relay 1: When a valid code is entered, the unit will activate relay 1.
Cycle Relay 2: When a valid code is entered, the unit will activate relay 2.
Latch Relay 1: When a valid code is entered, the unit will activate relay 1 until it
is released by an entry code that is programmed either to "Release Relay 1" or to
"Release Both".
Latch Relay 2: When a valid code is entered, the unit will activate relay 2 until it
is released by a code that is programmed either to "Release Relay 2" or to
"Release Both".
Release Relay 1: When a valid code has been entered, the unit will deactivate
relay 1. For example, if relay 1 were previously latched open, this code would
cause it to close.
Release Relay 2: When a valid code has been entered, the unit will deactivate
relay 2. For example, if relay 2 were previously latched open, this code would
cause it to close.
Cycle Both: When a valid code is entered, the unit will activate both relays.
Release Both: When a valid code has been entered, the unit will deactivate
relays 1 and 2. For example, if relays 1 and 2 were previously latched open, this
code would cause them to close.
3 N
ame (optional): Click in the Name box and enter a name. This entry can be up to 31
characters in length and can include letters, numbers, and punctuation marks.
4 Click the Save button to save the entry code.
5 To enter more codes, repeat steps 1 through 4.
6 Click the Done button when all entry codes are entered. You will be returned to the Work
On Unit screen.
NOTE: Capacity Used/Remaining tracks the number of codes assigned and indicates
how many available codes remain. If the number of access codes used exceeds the
capacity, the Capacity Used number will turn red. You will not be allowed to send data
to the unit until the excess codes are deleted.
Editing an Entry Code
1 Open the Add/Edit Entry Codes screen (see Figure 17).
2 In the Entry Codes list, click the record you want to edit.
The data displays in the corresponding boxes at the top of the screen.
3 Click in the appropriate box(es) and edit the data. NOTE: To edit an entry code itself
(i.e., the number), you must delete the record that you want to change and add a new
record to replace it.
4 Click the Modify button after editing the entry code data.
5 To edit more entry codes, repeat steps 2 through 4.
6 Click the Done button when editing is completed. You will be returned to the Work On
Unit screen.