Instructions / Assembly

10
TOOLS AND HARDWARE REQUIRED / OUTILS ET QUINCAILLERIE REQUIS / INSTRUMENTAL Y HERRAJE REQUERIDOS
• Place a Bench Assembly (BWN) underneath one of the Legs and slide the Sliding End Caps under the glide rails of
the Bench Assembly as shown.
• Posez un ensemble du banc (BWN) sous les pieds de la table, et insérez les capuchons glissants sous les rails
comme illustré.
• Coloque un conjunto de banco (BWN) debajo una de las patas, y deslice los tapones corredizos debajo los rieles
como se muestra.
Glide Rails / Rails / Rieles
Sliding End Caps / Capuchons glissants / Tapones corredizos
BWN
1.6
1.7
u SECTION 1 (CONTINUED) / SECTION 1 (SUITE) / SECCIÓN 1 (CONTINUACIÓN)
BWI
BWI
• Lay the Table Legs and Table Leg Braces down flat on the Table Top. Place a Sliding End Cap (BWI) on the ends of
one of the tubes on a Table Leg as shown.
• Étendez les pieds et les supports de pied par le tableau. Attachez un Capuchon glissant (BWI) sur les extrémités d’un
tube du pied comme illustré.
• Extienda las patas y los soportes por el tablero. Coloque un tapón corredizo (BWI) sobre cada extremo de los tubos
de las patas en forma de «W» como se muestra.
BWH
BWH
BWI (x2)