Instructions / Assembly

21
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
1MBDFUIF1PMFBTTFNCMZPOUIFHSPVOEXJUIUIF8BSOJOH4UJDLFSPOUIF
.JEEMF1PMF"-'GBDJOHEPXO1PTJUJPOUIFwYw"YMF"+$ under the
bottom slots of the Base (AJM)BTTIPXOBOETUFQPOUPUIF#BTFTPUIF
"YMFTOBQTJOUPUIFTMPUT5IFOSPUBUFUIF1PMFBTTFNCMZVQXBSETPUIBU
the 1/2” x 7” Axle (AJE)TOBQTJOUPUIFVQQFSTMPUTPGUIF#BTFBTTIPXO
SEC
2.3
AJC
AJM
BTSY
1/2"Y
AJE
AJM
BZOY
Attach the Pole Braces (ALI) to the Bottom Pole (ALE)XJUIUIFIBSEXBSF
TIPXOBOEtighten all Pole to Base assembly hardware.
SEC

BTS
BZO
ALE
ALI
Note: Tip the system forward so the Pole rests on the ground. Do not stand
the system up until it is fi lled with either sand or water later in the assembly.
!
ALI
3/16"Y