Use and Care Manual
www.culer.com | 1-800-320-6478Rev. 11.17.15 3
Operation
1. Remove tank cap and ll water
tank (with potable water only)
to the bottom of the ll
basket. (approximately one
gallon)
NOTE: Do not overll tank.
2. Replace cap and tighten until
fully sealed.
NOTE: Unit will not function properly if cap
is not tight.
3. Plug AC/DC power adapter
supply into the power port on
the unit. Plug the three-
pronged plug into an outlet.
4. Press the POWER button at
the top of the unit to turn on
the evaporative cooler. Green
light will illuminate.
10. Do not block or tamper with the atomizing nozzles, as it may
reduce or impede the product’s performance.
11. Disconnect the power cord before moving or performing any
maintenance on the product.
12. This product must be grounded. Plug into an appropriate ground
fault circuit interrupter (GFCI) protected outlet that is properly
installed and in accordance with all local codes and ordinances.
13. Do not hang or mount the product on a wall or ceiling.
14. This product should not be used in potentially dangerous
conditions, such as ammable, explosive, or chemically loaded
atmospheres.
15. Do not store outside or near hazardous materials.