R CULER SOLOTM and DUETTM Owner’s Manual Thank you for choosing CULER. PLEASE READ THESE INSTRUCTIONS AND KEEP THIS OWNER’S MANUAL IN A SAFE PLACE. Rev. 11.17.15 www.culer.
Table of Contents PAGE Contents ......................................................................... Safety .............................................................................. Operation ....................................................................... Care ................................................................................. FAQ ................................................................................. Troubleshooting..................................................
10. Do not block or tamper with the atomizing nozzles, as it may reduce or impede the product’s performance. 11. Disconnect the power cord before moving or performing any maintenance on the product. 12. This product must be grounded. Plug into an appropriate ground fault circuit interrupter (GFCI) protected outlet that is properly installed and in accordance with all local codes and ordinances. 13. Do not hang or mount the product on a wall or ceiling. 14.
5. Press the FAN button to turn on fan. Adjust air speed by pressing button: (high, med, low) Green light will illuminate. 6. Press the COOL button to activate atomization. Green light will illuminate. 7. Adjust the cooling port(s) to the desired positions up-down and side-to-side. POWER OFF Press the POWER button to turn off. Green light will turn off. NOTE: The CULER evaporative cooler will continue to atomize for a short time while the unit depressurizes.
Care CLEANING & STORING PRODUCT • Clean the cooler with a soft cloth and mild soap solution. • Store the cooler in a clean and dry place. • DO NOT STORE COOLER WITH WATER IN THE SYSTEM FOR MORE THAN 5 DAYS. No Water in System When Storing EMPTYING WATER TANK • Unplug the power supply. • Remove the water tank fill cap. • Carefully turn the cooler over to allow water to drain out. Rev. 11.17.15 www.culer.
• Replace fill cap and turn until sealed. • Plug the cooler in and run COOL function until the atomized water stops. CONDI CONDITIONING WATER TANK • If an unpleasant odor is detected, a quick conditioning of the water tank should correct the issue. • Completely drain water tank. (See Emptying Water Tank) • Fill tank with 1 gallon of potable water. NOTE: Do not overfill tank. • Add 3 to 5 drops of unscented chlorine bleach to the full water tank. 6 www.culer.com | 1-800-320-6478 Rev. 11.17.
• Replace cap and turn until sealed. • The cooler is conditioned and ready for operation. REPLACING FILTERS NOTE: Each cooler has two filters: one for water and one for air • Locate the filter access doors on the sides of the cooler. • Place small flathead screwdriver into slot on access door near back of unit and gently move the screwdriver towards back of unit until door can be removed. • The filters are connected to the tubing at the blue fittings. Rev. 11.17.15 www.culer.
• Press the blue fittings towards the middle of the filter while gently pulling the tubing out of the filter. • Orient the red band in the new filter towards the rear of the cooler. • Firmly insert tubing into the fittings on either side of the replacement filter. • Reinstall filter access door. Repeat steps for filter on opposite side. 8 www.culer.com | 1-800-320-6478 Rev. 11.17.
Recommended Optimal Operating Placement Legend: = Placement Window Table Table Table Table Table Table Entry Way GOOD AREAS RECOMMENDED CLEARANCE • On floor with good airflow example - by entryway of room • Near open window • On a table • Directed towards user(s) • 3 feet (0.9m) from front 3 feet (0.9m) CAUTION: DO NOT COVER UNIT WITH FABRIC Rev. 11.17.15 www.culer.
FAQ What is the run time with COOL on and how much water does it take? SOLO – 10 + hours DUET – 6 + hours Both the SOLO and DUET will hold up to 1 gallon of water. Can it be left outdoors? It is not recommended to leave your cooler outside when it is not being used. (Think of it like a portable stereo - you can use it outdoors, but not recommended to leave outdoors.) Where can you use the CULER evaporative coolers? The CULER evaporative coolers were designed to be used both outdoors and indoors.
Troubleshooting PROBLEM CAUSE CORRECTION a) POWER button is in the OFF position a) Press POWER button one time b) Power cord is not connected b) Connect power cord and press POWER button one time c) Wall outlet is not providing power c) Find an alternate power outlet No air coming from port FAN button is in the OFF position Press FAN button to activate (high, med, low) No atomization coming from port a) COOL button is in the OFF position b) Water tank is empty c) Tank cap is not fully tightened
Warranty 1 YEAR LIMITED WARRANTY • The CULER evaporative cooler is warranted for one year from the date of purchase against defects in materials and workmanship. At our discretion, parts that prove to be defective will either be repaired or replaced, or the whole product will be replaced. In either case, a copy of your proof of purchase will be required.
