Warranty

12
OPERATING INSTRUCTIONS
4. To set the timer to power off the heater, start
the unit and press the Timer button on the con-
trol panel (C) or remote control (B).
Note: The timer-power-off function can only be
set when the heater is in power-on mode.
The digital display on the control panel (C)
changes from the set temperature readout
to a time value for the timer. Press the Timer
button repeatedly to change the number value
between a range of 0 to 12 hours (in 1-hour
intervals).
4
C
B
5. To set the timer to power on the heater, first
ensure the unit is powered off, then press the
timer button on the control panel (C).
Note: The timer-power-on function can only be
set when the heater is in power-off mode.
The digital display on the control panel (C) will
indicate time value for the timer. Press the
Timer button repeatedly to change the number
value between a range of 0 to 12 hours (in
1-hour intervals).
5
C
B
6. To power on or adjust the flame effect bright-
ness, press the Flame Effect button on the
control panel (C) or short press the Flame Ef-
fect Button on the remote control (B)
Note: The flame effect function can be set when
the heater is on or off.
The unit will cycle between, high, medium, low
and off brightness levels
6
C B
7. To replace the batteries, remove the battery
cover (1) from the remote (B) by applying pres-
sure to the battery cover (1) and sliding it away
from the remote (B). Insert two AAA batteries
(not included) (2) and close the remote by plac-
ing the battery cover (1) back on the remote
(B).’
Note: Do not mix old and new batteries. Do not
mix alkaline, standard (carbon-zinc), or
rechargeable (NiCad, Ni-Mh, etc) batter-
ies.
7
B
1 2