Installation Guide

16
Press the Brightness button on the remote control to change
the Fuel bed color between the 3 settings: High, Middle and
Low. Indicated by the second digit on the Floating Display™
changing to show: "P" (high), "C"(middle) and "L" (low).
Operation
Operation (continued)
Push the Power button to supply power to all functions
of the fireplace and put the wall fire in a standby mode.
Push the Power button again to turn off all functions.
Press the Timer button on remote to cycle through the nine
timer settings (30 minutes, 1Hour, 2H, 3H, 4H, 5H, 6H,
7H, 8H ) and the OFF setting.
1
3
2
6
Powering the Fireplace
Adjusting the Flame Effect
Adjusting the Heater
Setting the Timer
NOTE: To change between °F and °C ,hold the button
NOTE:
All previous settings are held in memory, so the next
the same settings.
Turns the Flame Effect On and Off, actived by pressing the
button on the remote. Cycles the unit through the
four settings:
‘FE’, Flame and Fuel bed ON.
‘F-’, Flame ON, Fuel bed OFF.
‘-E’, Flame OFF, Fuel bed ON.
‘--’, Flame and Fuel bed OFF.
Adjusting the thermostat
Press the Thermostat button on the control panel to
change the setting temperature.
Adjusting the Brightness
4
5
The thermostat setting range is 59°F - 86°F or 15°C
- 30°
The thermostat is adjustable by 1°F or 1°C
increments by
pressing the Up or Down “ “ buttons on the remote
control or buttons on control panel.
Turns the Heater On and Off, actived by pressing the
button on the remote or control panel. Cycles the unit
through the three settings:
NOTE:
The unit can be operated in Press and hold
the button on the control panel (not by using the remote)
for more than 5 seconds, to change to Demo mode. The
heater and thermostat are disabled, and "dE" will be
displayed on the Screen Display. Press and hold again for
5 seconds to exit Demo mode.
C.
The default temperature setting is 77°F (25°C)
down, then press and hold the button on the
control panel for 5 seconds, or vice versa.
That can be only operated on the control panel.
NOTE: When the Theme is on cycle, the brightness button
can be only for stop/hold or release cycling.
Icon is indicated on display when timer is on and working.
NOTE:
The unit can be operated in when the unit
is only running with the heater, the (low heat) or the
(high heat) icon and the intake temperature will
continuously be displayed on the On Screen Display.
‘H2’, High Heat. Indicated icon on display.
‘H1’, Low Heat. Indicated icon on display.
Blower and Heater OFF, Indicated icon is off.
NOTE:
After the heater is switched off, there is a 60 seconds
fan delay, where the fan will continue running before
turning off.
time you power up the fireplace, the unit will turn on with