INFRARED HEATER lifesmart® is a registered trademark of Supply Chain Sources LLC., All Rights Reserved. Customer number: PCHT1109US, HT1109 UNIT LEGS LOCATED UNDERNEATH THE BOTTOM MOST PACKAGING FOAM ATTACH YOUR RECEIPT HERE Purchase Date ____________Serial Number (located on back of unit) __________________ Questions, problems, missing parts? Contact technical support department at 657-341-0362, 9:00 a.m. - 5 p.m., PST, Monday - Friday or visit us online at www.lifesmartcomfort.
TABLE OF CONTENTS Package Contents. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Frequently Asked Questions . . . . . . . . . . . . . . . . .
PACKAGE CONTENTS A B C F E D PART DESCRIPTION QUANTITY A Infrared Heater 1 B Remote Control 1 C Control Panel (preassembled to Infrared Heater (A)) 1 D Air Intake Vent (preassembled to Infrared Heater (A)) 1 E Master Power Switch 1 F Unit Legs (*assembly required, see pg8) 4 3
SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate, or install the product. IMPORTANT SAFETY INSTRUCTIONS WARNING: POTENTIAL ELECTRICAL HAZARD IF NOT ADHERED TO. When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: • • • • • • • • • • • • • • • • • • • • This heater must be plugged into a 120 V, 15 amp (or more) circuit of its own.
SAFETY INFORMATION Child Lock Safety Feature Press and hold the flame button on the remote control (B) for 5 seconds. Locking is confirmed when a buzzer rings. When locked, the control panel and remote control (if provided) will not function. To unlock the control panel or remote (if provided), repeat this procedure. Unlocking is confirmed when a buzzer rings. Tip-Over Safety Feature This heater is equipped with a tip-over safety feature.
FREQUENTLY ASKED QUESTIONS Please review these frequently asked questions on the next few pages prior to using your heater. Q. My heater emits a strange odor when I first open the box and when I turn the heater on for the first time. Why is this happening? A. This is normal. This heater is treated with a special heat safe/resistant coating. This odor will sometimes be present when the box is opened.
FREQUENTLY ASKED QUESTIONS Q. The temperature on my heater does not match the temperature display on my wall, or external thermostat. Why? A. This is completely normal. The temperature display on your heater may vary from the temperature display on another thermostat (like the one mounted to your wall or a purchased external thermostat). This is because the temperature sensor on the heater reads the temperature directly around the heater.
PREPARATION Place the heater on a firm, level surface and plug into a grounded 120 V, 60 Hz power outlet and turn on the unit. Only operate heater in upright position. Insert two AAA batteries into the remote control before using (batteries not included). *(Not all products will include a remote control.) Please note that infrared heaters do not heat like a traditional space heater. You should not expect infrared heaters to blow hot air like a traditional space heater. Infrared heaters heat objects not air.
TROUBLESHOOTING PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION The heater does not turn on. 1. The power cord is not plugged in. 1. Plug the power cord into an electrical outlet. 2. The electricity at the main fuse box is not working. 2. Check the electricity at the main fuse box. 3. The master power switch is not in the ON position. 3. Switch the master power switch to the ON position. The flame effect does not turn on 1. The flame intensity is low. 1.
CONTROL PANEL 8 9 High Low 1 PART 2 3 4 NAME 5 6 7 DESCRIPTION 1 Heater Mode Button Toggles between Hi / Low Heat Modes 2 Temp-Up Button Increases the set temperature 3 Temp-Down Button Decreases the set temperature 4 Timer Button Engages the on/off timer function 5 Flame Effect Button Toggles the Flame Effect ON / OFF and between the varied flame effect brightnesses 6 Power Switch Button Powers the heater ON or OFF 7 Digital Display Readout of the set room temperat
REMOTE CONTROL 1 6 2 3 5 PART 4 NAME DESCRIPTION 1 Temp Up Button Increases the set temperature value 2 Heater Mode Button Toggles between the three heat modes available 3 Temp Down Button Decreases the set temperature value 4 Power Button Powers the heater on or off 5 Flame/Lock Button Short press: Toggles the Flame Effect from High/Med/Low/Off. / Long press: for 3 seconds to activate lock function.
OPERATING INSTRUCTIONS 1. Turn the heater on or off by pressing the Power button on the control panel (C) or by pressing the Power button on the remote control (B). 1 Once the power is off, heating elements will stop working first. The fan will continue working for up to 90 seconds to dispense residual heat inside the heater. This is a normal function. C B C B 2 2.
OPERATING INSTRUCTIONS 4. To set the timer to power off the heater, start the unit and press the Timer button on the control panel (C) or remote control (B). 4 Note: The timer-power-off function can only be set when the heater is in power-on mode. C B C B C B The digital display on the control panel (C) changes from the set temperature readout to a time value for the timer. Press the Up/Down buttons repeatedly to change the number value between a range of 0 to 12 hours (in 1-hour intervals). 5.
CARE AND MAINTENANCE WARNING: Before performing any maintenance task, turn off the power switch in the front of the unit, unplug the unit, and allow it to cool completely. 1. To keep the heater clean, clean the outer shell with a soft, damp cloth. Use a mild detergent if necessary. After cleaning, dry the unit with a soft cloth. CAUTION: DO NOT let liquid enter the heater. 2. DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the heater.
ONE-YEAR LIMITED WARRANTY The manufacturer warrants this heater against defects in materials and workmanship on functional parts, for a period of 1 year from the original date of purchase. Your sales receipt showing the date of purchase of the product is your proof of purchase. Keep it in a safe place for future reference. This warranty is subject to personal use only, commercial or rental applications will not be covered.
REPLACEMENT PARTS LIST For replacement parts, call our technical support department at 1-800-752-5262,, 8 a.m. - 5 p.m., CST, Monday - Friday PART A DESCRIPTION PART # A Control panel COPA-RF19 B Fan C Power board D Manual Reset Limit Sensor LIMIT130 E Reset Limit Sensor LIMIT120 F Heating Element QUARTZ-RF500 G Thermostat Wire SENSOR H Remote control REMO-F FAN-RF19 POBO-RF19 B C G D E F H PLEASE REMEMBER TO REGISTER YOUR WARRANTY: web: www.lifesmartcomfort.
