Installation Guide

13
OPERATING INSTRUCTIONS
4. To set the timer to power off the heater, start
the unit and press the Timer button on the
control panel (C) or remote control (B).
Note: The timer-power-off function can only
be set when the heater is in power-on
mode.
The digital display on the control panel (C)
changes from the set temperature readout to
a time value for the timer. Press the Up/Down
buttons repeatedly to change the number
value between a range of 0 to 12 hours (in
1-hour intervals).
4
C
B
5. To set the timer to power on the heater, first
ensure the unit is powered off, then press the
timer button on the control panel (C).
Note: The timer-power-on function can only
be set when the heater is in power-off
mode.
The digital display on the control panel (C)
will indicate time value for the timer. Press
the Up/Down buttons repeatedly to change
the number value between a range of 0 to 12
hours (in 1-hour intervals).
5
C
B
6. To power on or adjust the flame effect bright-
ness, press the Flame Effect button on the
control panel (C) or press the Flame Effect
Button on the remote control (B)
The unit will cycle between the four
brightness levels.
6
C
B
7. To replace the batteries, remove the battery
cover (1) from the remote (B) by applying
pressure to the battery cover (1) and sliding
it away from the remote (B). Insert two AAA
batteries (not included) (2) and close the re-
mote by placing the battery cover (1) back on
the remote (B).’
Note: Do not mix old and new batteries. Do not
mix alkaline, standard (carbon-zinc), or
rechargeable (NiCad, Ni-Mh, etc) bat-
teries.
7
B
1 2