Instructions / Assembly

6
TROUBLESHOOTING
PROBLEM SOLUTION
Humidifier power indicator light is
staying red and not turning green:
1. Ensure that the water tank cap is secured properly to
water tank.
2. Empty out water in humidifier base. Place filled water tank
on to empty humidifier base.
3. Clean Water Level Sensor. To clean the water level sensor,
snap off the plastic cap from the pin. Remove the water
level sensor float and clean by wiping the parts with a soft,
damp cloth. Replace the parts by first putting the water
float onto the pin and replacing the plastic cap on pin.
If humidifier does not have any power: 1. Ensure unit is properly plugged into a power outlet.
2. Check that the Control Knob is turned to the ON position.
3. If Power On indicator light does not come on, contact
technical support
If there is a strange odor 1. Clean the Water Tank with the water and vinegar solution
and rinse with clean water.
2. Leave the empty Water Tank open for some time (without
the Water Tank Cap attached) in a cool place.
The power indicator light is green, but
there is no mist being emitted:
1. Check that there is water in the Water Tank.
2. Make sure that nothing is blocking the Mist Lid.
3. Check that the Fan Vent on the bottom of the humidifier is
not blocked.
4. Empty and rinse the Humidifier Base with cool tap water.
5. Check for possible mineral deposits on the Water Level
Sensor and Nebulizer.
White dust appears and settles
outside the humidifier:
1. Your area tap water may have too many minerals.
Change to filtered or distilled water or purchase a
demineralization filter cartridge.
PREPARATION
CAUTION: DO NOT operate the humidifier without water in the Water Tank.
CAUTION: DO NOT plug or unplug the Power Cord with wet hands as electric shock could occur.
CHECK HUMIDIFIER PLACEMENT: Place the Humidifier on an elevated, non-metallic, lint-free, waterproof,
level surface at least 2 feet above the floor.
DO NOT place the humidifier on carpet or a towel. The fan vent is located on the
bottom of the humidifier base. The fan vent MUST NOT be obstructed.
DO NOT place the humidifier on a wood surface or near furniture that can be
damaged by too much moisture.
CHECK WATER LEVEL SENSOR: Make sure that the Water Level Sensor is secured properly and not
obstructed.