Use and Care Manual

6
PREPARATION
NOTE: DUE TO THE HIGH VELOCITY OF AIR GENERATED BY THIS FAN, HEARING THE SOUND OF THE
AIR IS NORMAL. FOR QUIETER OPERATION, USE LOW SPEED.
1. Carefully remove the fan from the plastic bag and carton.
2. Using the included screws align the two base pieces and secure using a phillips screw driver as
shown in the illustration below.
1 2
3
3
3
3. Place the Fan on a firm level surface.
4. Remove plastic strip from the remote control to enable battery contact.
5. Plug the cord set into a 120 volt outlet.
WARNING: Be sure that the plug fits tightly into outlet. When plugs fit loosely into receptacles, they
may slip partially or completely out of the receptacle with only the slight movement of the attached cord.
Receptacles in this condition may overheat and pose a serious fire hazard; if covered by a curtain or drape,
the fire hazard is even greater.