User's Manual

BHS-i100 Installation and Programming Instructions
Device Level Options
Using the programmer, enter the Advanced Menu and select
Device. In the Device Menu, select Auxiliary Siren. Select the
Siren (#1 - #4) to be configured. There will be 6 Device Level
Options to be configured for each Siren installed on the system.
Enable
Default value: Yes – enables the device
Select No – disables the device
Assign Name
Default value: “External Siren”
Use key pad to change name
Chime Tone Enable (System door chime mode must be
enabled)
Default value: Yes – allows door chime to play
Select No – chime will not play
Exit Tone Enable
Default value: Yes – tone plays during exit delay
Select No – no tone during exit delay
Entry Tone Enable
Default value: Yes – tone plays at Siren until code is entered
Select No – no tone at Siren during code entry
Alarm Tone Enable
Default value: Yes – Siren sounds during alarm
Select No – Siren does not sound during alarm
2.5.5 Trouble Messages
Trouble Messages will appear to indicate the following:
59 Not Ready
S01 – S04 Low Bat (rotating status)
S01 – S04 No AC (rotating status)
7