Installation and Programming Guide SS470 Auxiliary Siren-Strobe SSC1000 Auxiliary Siren-Strobe October 13, 2006 Draft
BHS-i100 Installation and Programming Instructions 1 Regulatory Notices ...........................................................3 1.1 FCC Rules Part 15.......................................................3 2 InGrid Component Installation and Registration ...............4 2.1 Components.................................................................4 2.2 Maximum System Capacity .........................................4 2.3 Wireless Communications Range................................4 2.
BHS-i100 Installation and Programming Instructions 1 Regulatory Notices 1.1 FCC Rules Part 15 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by InGrid, Inc. can void the user’s authority to operate the equipment.
BHS-i100 Installation and Programming Instructions 2 InGrid Component Installation and Registration Important Note 2.1 Please read and fully understand the BHS-i100 User’s Manual before reading this manual or attempting to install the system. The User’s Manual describes the system’s features, functions, and user interface requirements in great detail. That information is not repeated in this manual Siren-Strobe to Grid Extender – This communication operates at 345 MHz and 2.4 GHz.
BHS-i100 Installation and Programming Instructions does not receive power from the Power Supply, switch the polarity of the wire connections on the Power Supply. 5. The Power Supply contains a tab that protrudes above the Power Supply. The Power Supply must be mounted so that the hole in the tab is aligned with the center screw hole of the outlet cover.
BHS-i100 Installation and Programming Instructions 4. 2.5.1 Learn The Auxiliary Siren 1. Using the Programmer, navigate to “Learn Devices”, then “Learn Auxiliary Siren”. Registration will be enabled for 60 seconds only. The Programmer will display: Assign Siren to Siren #1? 1=YES 2=NO Install Siren on Mounting Bracket To Register 2. If the Auxiliary Siren successfully qualifies, the Programmer will display: 5. The process may be repeated until all Auxiliary Sirens are registered. 2.5.
BHS-i100 Installation and Programming Instructions Device Level Options Using the programmer, enter the Advanced Menu and select Device. In the Device Menu, select Auxiliary Siren. Select the Siren (#1 - #4) to be configured. There will be 6 Device Level Options to be configured for each Siren installed on the system.
