User's Manual

Mount Bracket and Magnet
1. Attach double-sided tape to the bottom of the
Magnet.
2. Attach Magnet to the door.
3. Attach double-sided tape to the bottom of the
Bracket.
4. Attach the Bracket to the door frame.
Bracket and Magnet Installation
Windows
The process for mounting a Bracket and Magnet to a
window is very similar to installing on a door. See the
door installation instructions, above.
Various mounting positions that work for attaching
sensors to windows:
Option 1
Option 2
Options 1 and 2: Standard window mounting
placement
Option 3: Less Common window mounting placement
Note: If your window frame does not provide enough
room for mounting the bracket you may need to use a
sensor extension. See Sensor Extension Section.
See the User Guide for more window installation
options.
Install the Sensor
Once the Bracket and Magnet are attached to the door
or window, Sensors may be installed. You will need to
have the Handset with you to install the Sensor.
Remove the battery tab from the Sensor
On the Handset
Enter the Security Menu
Before clipping the Sensor into the Bracket, enter the
Security menu on your Handset.
o Scroll to Setup and press SELECT
o Scroll to Security and press SELECT
o Enter Master Code and press SELECT
Install the Sensor
o Scroll to Sensors and press SELECT.
o Press the SELECT key to <Add New>.
o Scroll to the type of Sensor (Door, Window,
etc.) and press SELECT.
o Wait 5 seconds before clipping the Sensor
into the Bracket. You will then have 30
seconds to complete the installation. The
display shows you the time remaining.
Clip Sensor into
Bracket
30 seconds
CANCEL
o Clip the Sensor into the Bracket
The Handset will beep when system finds the Sensor.
This may take a few seconds.
Scroll
up/down
Pull