User Manual

Signal Extender 5
Maximum Humidity: ........................................................................... 90% relative humidity, noncondensing
Dimensions:.....................................................................2.9” (7.4 cm) W, 4.7” (11.9 cm) H, 1.7” (4.3 cm) D
US Patents 6,888,459 and others pending
Note: The Signal Extender contains a backup battery. The battery must be replaced within 7 days when a low
battery condition occurs to ensure that system events can be reported in the event of a power outage. Replace only
with an InGrid IG180 battery. There is a risk of explosion if an incorrect type of battery is installed.
NOTICES
FCC Part 15 Information
Changes or modifications not expressly approved by InGrid, Inc. can void the user’s authority to operate the
equipment. This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against interference
in a residential installation.
FCC RF Radiation Exposure Statement: This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20
centimeters between the radiator and your body.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the equipment or the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the affected equipment and the panel receiver to separate outlets, on different branch circuits.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Part 15 ID No. S9PSE430
ACTA Part 68
This equipment complies with Part 68 of the FCC Rules. Located on this equipment is a label that contains, among
other information, the FCC registration number and the ringer equivalence number (REN) for this equipment. If
requested, this information must be provided to the telephone company.
ACTA Registration No. S9PAL01BSE430
The REN is used to determine the maximum number of devices that may be connected to your telephone line.
Excessive RENs on a telephone line may result in devices not ringing in response to an incoming call. In most areas,
the sum of all device RENs should not exceed five (5.0). To be certain of the number of devices that may be
connected to a line, as determined by the total RENs, contact the local telephone company. For products approved
after July 23, 2001, the REN for this product is part of the product identifier that has the format
US:AAAEQ##TXXXX. The digits represented by ## are the REN without a decimal point (e.g., 03 is a REN of 0.3).
For earlier products, the REN is separately shown on the label.
This equipment is equipped with a USOC RJ31X connector. This equipment is designed to be connected to the
telephone network or premises wiring using a compatible modular jack (RJ31X) which is part 68 compliant.
Alarm dialing equipment must be able to seize the telephone line and place a call in an emergency situation. It must
be able to do this even if other equipment (telephone, answering system, computer modem, etc.) already has the
telephone line in use. To do so, alarm dialing equipment must be connected to a properly installed RJ31X jack that
is electrically in series and ahead of all other equipment attached to the same telephone line. Proper installation is
depicted in the following diagram. If you have any questions concerning these instructions, consult your local
telephone company or a qualified installer about installing an RJ31X jack and alarm dialing equipment for you.