User's Manual

Using the Key Chain Remote Control
The Key Chain Remote Control may be used to perform various
functions depending on the state of the security system. Depending on
the state of the system, button presses will result in the system arming or
disarming confirmed with either red or green blinks from the remote and
audible beeps.
Turning the System ON
• Press ON or M-OFF button to arm the system
– System Ready: Red LED blinks and single chirp to
confirm house is secure
– System Not Ready: 6 red blinks and 6 chirps to
indicate the system is not ready. The system does
not arm.
– Secure the non-secure zone and repeat arming
process.
– No feedback; out of range
Turning Motions ON and OFF without disarming
• Press ON or M-OFF while system is armed. These commands
shall allow the user to toggle between Armed with Motions-ON
and Motions-OFF without disarming the system.
– System Armed with Motions Off: Press M-Off; no
change; no LED blink
– System Armed with Motions Off: Press ON;
Motions turn on; Green LED blink
– System Armed with Motions On: Press ON; No
change; no LED blink
– System Armed with Motions On: Press M-Off;
Motions turn off; Green LED blink
Turning the System OFF
• Press OFF button
– System Armed/No Alarm Memory: Green LED
blinks and single chirp to indicate the system is
disarmed