User's Manual

7. The installer may enter a new number, or press [Enter] to select the
default user number value. Note that the Key Chain Remote will
only become active if the selected user number is enabled. A
Key Chain Remote cannot be added to users 9-13. If the installer
enters a user number which is currently in use, the Programmer will
display:
o OK to overwrite
o User 2?
o 1=YES 2=NO
o
8. The process may be repeated until all Key Chain Remotes are
registered.
Troubleshooting Key Chain Remote Registration
Problem: A Key Chain Remote is registered into a neighboring
system
Symptom: Local Programmer doesn’t “triple beep” or show the
request for qualification step.
Recovery: Use the Programmer and go to Learn Devices; Learn
Keyfob and press all 4 buttons simultaneously. Press any
key on the key fob.
Problem: A Key Chain Remote from a neighbor’s home is
registered into the local system.
Symptom: During the registration process, a Key Chain Remote was
registered into a particular zone. During a Zone Finder
test, no local Key chain remote matches the zone.
Recovery: On the Programmer, navigate to Advanced; Device;
Keyfob and delete the zone containing the unknown Key
Chain Remote.
Problem: A Key Chain Remote will not register.
Symptom: During the registration process, a Key chain remote is
inserted but the Programmer does not recognize the Key
Chain Remote. No registration message appears to be
transmitted. Key Chain Remote may be registered to
another system.
Recovery: Use the Programmer and go to Learn Devices; Learn
Keyfob and press all 4 buttons simultaneously. Press any
key on the Key Chain Remote. Repeat the registration
process.