User's Manual

o Press All four
o Buttons on KeyFob
o To Register
2. While holding the Key Chain Remote near the Programmer (within 1
foot is preferred), press all 4 buttons on the Key Chain Remote. The
Programmer and the Keypads will triple beep. If successful, the
Programmer will display:
o Press Any
o Button to
o Complete Registration
3. If the Key Chain Remote fails to transmit within 15 seconds, the
Programmer will leave registration mode automatically. If a system
detects two different Key Chain Remote bursts during the Key
Chain Remote registration mode it will not register either Key Chain
Remote and the Programmer will leave registration mode
automatically.
4. The registration must be confirmed by pressing any Key Chain
Remote button. The Programmer will then display either:
o Keyfob
o REGISTERED
o Press ENTER
o to continue
or
o Keyfob
o NOT REGISTERED
o Press ENTER
o to continue
5. If the Key Chain Remote fails to qualify, the Programmer will return
to the “Learn Devices” menu.
6. If the Key Chain Remote successfully qualifies, the Programmer will
display:
o Assign Keyfob to
o User #
o > 1
o