User's Manual
BHS-i100 Installation and Programming Instructions
8
down until the hole in the tab is aligned with the center
screw hole of the outlet cover.
6. Insert the outlet screw through both the tab and the center
screw hole of the outlet cover as shown in Figure 4, and
tighten as necessary. The tab and the cover should be snug
against the outlet, but not so tight that it causes flexing or
stress on either the tab or the outlet cover.
7. Reconnect power to the outlet by turning the circuit breaker
on or replacing the fuse.
Figure 4
2.8 Install the RJ31X / RJ38X
One Grid Extender is designated at the Gateway Grid Extender
and must be connected to the telephone line using a RJ31X or
RJ38X jack. To install the RJ31X or RJ38X jack, do the
following:
2.8.1 Wire The RJ31X Jack As Shown:
Figure 5
2.8.2 Wire The RJ38X Jack As Shown:
Figure 6