User's Manual

BHS-i100 Installation and Programming Instructions
41
the sirens will sound the Temporal Code 3 cadence for the fire
alarm. The sirens and bells of all other alarms are overridden.
7.3.13 Local Zone
This zone type is a 24-hour zone which, when faulted, sounds a
one-second siren blast. All alarms are local. This zone can be
used to identify when a pool gate, a gun cabinet, a chemical
storage area, or a liquor cabinet is opened. A local alarm results
whenever the zone is faulted.
7.3.14 Carbon Monoxide Zone
This zone type is used for those zones to which a carbon
monoxide detector is wired. If carbon monoxide is detected, a
report will be sent with SIA gas alarm signals Gxzzz where zzz
is the zone number.
7.4 Blank And Sleep Modes
Blank Mode and Sleep Mode are used to either mask or
suspend the system’s operation. These features do not need to
be enabled or disabled in system programming.
NOTE If any of the system’s zones are
programmed as fire zones, the system
cannot be placed in Sleep Mode. However,
systems with fire zones can be placed in
Blank Mode.
Blank Mode. In Blank Mode, the system is completely
operational, but the Keypad’s LEDs and display are turned off.
The system can be armed and disarmed and can detect and
report alarm conditions. Blank Mode continues until the user
turns it off.
To enter Blank Mode:
1. If the system is on, turn it off by entering a user code.
33. Press and hold the CANCEL key for 15 seconds. When
prompted, enter the master user code.
To end Blank Mode:
34. Press and hold the CANCEL key for 30 seconds.
Sleep Mode. In Sleep Mode, the system shuts down for 24
hours. It cannot be armed or disarmed, and it does not detect or
report alarm conditions After 24 hours have passed, the system
automatically returns to normal operation.
To enter Sleep Mode:
1. If the system is on, turn it off by entering a user code.
35. Press and hold the CANCEL key for 15 seconds. When
prompted, enter the master user code.
36. Within the next ten seconds, press the CANCEL key again
(do not hold it for 15 seconds this time). Enter the master
user code again.
To end Sleep Mode:
Sleep Mode ends automatically after 24 hours have passed. To
end Sleep Mode sooner, call Customer Care at 1 (800) 445-
0872 for assistance.