User's Manual

BHS-i100 Installation and Programming Instructions
35
LED is steadily lit, the battery is good. (The Keychain
Remote takes one A23 battery.)
• Attempt to arm the system while standing in front of the
Keypad. If the Keychain Remote’s signals are being
received, the Keypad’s display will mirror the changing
status of the system. If the signals are not being received,
repeat the Keychain Remote learning sequence described
in section 2.15.
• Correct any not-ready conditions, then try to use the
Keychain Remote again.
• If the system is working properly, replace the Keychain
Remote. If the system is not working properly, replace one
or more GE’s.
5.4 Keypad Service Messages
The table lists the service (or trouble) messages displayed by
the icon Keypad, and the significance and corrective measures
for each.
Message Significance Correction
LINE CUT The telephone line
has been cut or
service has been
interrupted.
Hang up all
telephones. If the
telephone service
is interrupted,
instruct the
customer to call
the telephone
company.
Cxx LOW BATT,
CALL (800) 445-
0872
The voltage of the
backup on GE xx
has dropped below
3.1V.
Make sure the unit
is connected to AC
power. Allow the
battery 24 hours to
recharge. If
problem persists,
replace the battery.
Cxx NO AC The AC power to GE
number xx has been
lost.
Locate the GE
which is reporting
low power using
the GE Finder
function from the
programmer. If
there is electrical
power to the
building, check and
reset the circuit
breaker. Verify the
transformer wiring,
or transformer.
Replace GE if
necessary
Cxx TROUBLE
CALL (800) 445-
0872.
Communication
failure. The system
could not
communicate with
GE xx
Use the GE finder
feature to locate (
by process of
elimination if
necessary ) the GE
which is not able to
communicate.
Verify the GE has
power and is
responding
normally. Replace
the GE if
necessary.
TROUBLE,
CALL (800) 445-
0872. Also, the
display reads
“CP”
Communication
failure. The system
could not make a
report to the central
station.
Verify the
telephone service
is working. Verify
wiring connections.
Replace any
defective wires.
Replace GE if
necessary.
TROUBLE,
CALL (800) 445-
0872. Also,
display reads
“CF”
Device supervisory
problem. Caused by
wiring, power, or
communication
problem.
Verify the wire
connections.
Replace any
defective wires.
Replace GE if
necessary
TROUBLE,
CALL (800 445-
0872. In addition,
the display reads
“CH”
Host failure. The
control system could
not complete a call
to the Imagine.
Verify the
telephone service
is working. Verify
the system
programming.
Verify wiring
connections.
Replace any
defective wires.
Replace GE, if
necessary.
TROUBLE,
CALL (800) 445-
0872. In addition,
the display reads
“CJ”
RF Interference. The
Receiver has trouble
receiving messages
due to RF
interference.
Try to locate the
source(s) of RF
interference (such
as from cell
phones,
microwaves,
wireless phones or
devices, etc.) and
relocate them.
ZONE xx
TROUBLE
Trouble on zone. Use the zone
finder feature from
the programmer to
locate the zone. If
the trouble follows
a canceled fire
alarm, allow time
for any airborne
particles to
disperse. Replace
the detector if
necessary.
J Receiver Jammed Try to locate the
source(s) of RF
interference (such
as from cell
phones,
microwaves,
wireless phones or
devices, etc.) and
relocate them.